Question about Kenmore 24902 Top Load Washer

1 Answer

Kenmore washer runs, but stops, and then starting running again

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,224 Answers
Re: kenmore washer - Kenmore 24902 Top Load Washer Washing Machines

Its supposed to do that

Posted on May 07, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Water pump shorted out. Now will not stop running unless washer is unplugged

oops you shorted the control board and now it needs more fixing at more expense

Jul 13, 2016 | Kenmore Elite Oasis 27052 Top Load Washer

1 Answer

I just replaced one of the suspension springs in our Kenmore 417 frontload washer. When I turned the washer back on and tried to run a load, it will run for about 5 seconds then stop for about a minute...

can you give me some explanation on what you did to replace the spring?. did you have to take the washer apart?. check the wire. maybe you forgot or did not plug all the way a connector. or came apart. my impression is that something came loose and the computer is not detecting a connection.

Feb 09, 2011 | Kenmore 44042 Front Load Washer

1 Answer

My washer won't stop running.

This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the pump removes most of the water) machine.

First, see the Sears parts site for your washer:

Enter your model number (###.######) and you'll see a list of major sub-components with diagrams and parts.

This sounds like a Timer problem. See the following Whirlpool / Kenmore Service Manual for top load / direct drive washers. It has a troubleshooting section and test procedures.$FILE/L-55.pdf

Apr 06, 2010 | Kenmore 24032\24036 Top Load Washer

1 Answer

The Kenmore Elite washing machine gets an F1 code on the digital readout then stops. Once the start and stop buttons are cycled a couple of times the machine starts running again.

Check to see if the screens for your hot and cold water connections are plugged with grit.
Or else the problem might be due to factory defect in the control circuit board of this washer.

Mar 28, 2010 | Kenmore Oasis HE 27082 Top Load Washer

1 Answer

Modle 80 washer question?

ck motor wiring connection for burnt or dark connections also possible bad timer ..have known timer to cause motor to run both speeds at same time this causes motor to overheat and shut off

Aug 16, 2008 | Kenmore 22422 Top Load Washer

1 Answer

Modle 80 washer.

If in spin the water drains ok then your coupler is faulted, If not the motor is faulted.

Aug 16, 2008 | Kenmore 22422 Top Load Washer

1 Answer

Cycle stops...

replace the lid switch, or check the connections it might even be your pusing rod for activating the switch

Jun 17, 2008 | Kenmore 24032\24036 Top Load Washer

1 Answer

Kenmore Oasis HE Washer

problem started when washer started itself up twice in the middle of the night....after that the washer seems to have problems figuring out what it wants to do...when running a wash it will start, run for 2 minutes then start scanning does not land on a will spin, stop, start...sears has replaced the mother board 3 times....and we will be phoning them again as it has not fixed the other time it did not spin properly and clothes were wet...we have a dedicated surge protector on it...we have had our electrical checked and no problems there...sears confirmed that as well..the techs have given up on it and don't know what to do with is still under warranty and now costing sears more to service it then replace it....time for them to do the right thing and "take it back"...very disappointed in this washer...wish me luck when i call them again...they must be sick of hearing from

Apr 26, 2008 | Kenmore Oasis HE 27082 Top Load Washer

Not finding what you are looking for?
Kenmore 24902 Top Load Washer Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Jesus  Colon
Jesus Colon

Level 1 Expert

12 Answers

Fred Sops

Level 2 Expert

271 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides