I hava a 55 inch . That now has a shadow and the picture isnt very crisp anymore . I know its the tv not the cable. Can the tv be adjusted ?

Look for picture size or zoom on remote...

There are some semiconductors or capacitors that are leaky. Might need thorough check up inside the TV.

Check and setup your coulor setting.Good luck...

This tv problems it is call a convergence picture problems,it is dead.Tv have any colors lines R,G,B mis alignments,have colors shadows pictures or 3D pictures look alike?Yes,than the tv board that call a convergence board it is dead to causes this problems.The tv convergence board must have be repair like replacing 2 STK convergence ICS and some or all of it resistors too.Fix the tv convergence board to solved the tv convergence picture problems.The tvs shops will cost u like $300-350 for parts and labors.

Something is not right here--The green is adjustable in the TECH menu--did this person adjust or try to adjust in the customer or the TECH menu?

If you confirm actual model number I can tell you how to get into the TECH menu--yes--green will not adjust in customer menu--it determines geometry and is only adjusted in the TECH menu.

Also, this set requires any convergence adjustments to be done in 480 and then in 1080--if only adjusted in one mode the other will still be bad.

Let me know if you know how to adjust in TECH menu or not--with exact model number I can tell you how to get there.

If this helps you rate this solution as I do this here for free.

SD TECH

LCD and Plasma sets DO NOT have degaussers in them. That was for the old Picture Tube Models. Try using a DVD on it and let me know how it looks. It sounds like a cable issue, but I don't know what type of signal your using.

This is failure of convergence out ICs in TV. Qualified TV tech will replace convergence out ICs or board.

i think you need a new convergence board they rin from about 88.00 to about 140.00

you need to replace the convergence IC STK393-110 you can get it as well as picture installation instructions as well as free online tech support at the link I posted very good prices
http://servicemanuals.vstore.ca/

you have to have your ant/cable connected to but tunners on the back you should see a ant1 and a ant2 then select pip from your remote