For no apparent reason my i pod has stopped

remove the tape and just test that whether its recording or not and try to change the tape and then try

Often with printers there is a buildup of debris clogging the paper path. Another thing that happens is the rollers get shiny and don't grab the paper. Shiny rollers can be cleaned with alcohol wipes until they are grippy again.

Yes: 240 volt can be controlled by turning off 1 hot leg of 240V circuit.
But the tork 101 clock motor still requires 120Volts (unless you buy a tork 240volt 201 clock motor to replace the 120volt 101)

Copy following links for handy resource and wiring diagram:
http://waterheatertimer.org/Tork-timers-and-manuals.html#1101

http://waterheatertimer.org/images/Tork-1101-wired-to-control-240.jpg

In the wiring diagram above, it shows white neutral wire running to Tork 1101 timer terminal 2. Bring this white neutral wire from any nearby 120volt outlet.
In event that you do not have this white neutral wire, you can connect ground wire to terminal 2 and that will give 120volts to the 101 clock motor.
Completing circuit to clock motor using ground wire is violation of national electric code for many reasons, however the tiny clock motor only draws 3 watts, and you will remember to bring a white neutral wire to this timer at later date so you can sleep better at night.

Additional resources:
http://waterheatertimer.org/See-inside-main-breaker-box.html

http://waterheatertimer.org/images/Inside-Main-Breaker-Box-12.jpg

Gene
h

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

ok your monitor is a separate issue and start by checking the blue signal lead from the back of the monitor because for some reason the monitor isn't getting any images to show

are you able to boot up from this drive
are all the leads connected from the motherboard to this hard drive IDE/SATA other than the power lead to this POD? the pods connections may be faulty

update your firmware or reset the i pod it will solve your problem

we had a hyundai once, that stopped and started for no apparent reason , after much looking at and mechanics it turned out to be some butterfly or non return valves leading from the fuel pump to the engine. they were closing up and stopping fuel from passing through , might be the same kind of thing . hope this helps

This sounds like it might be a defective CCD imager. If so, Canon should fix this for you for free, including free shipping both ways. This is regardless of your camera's warranty status. Please check the following two links for more info:

http://camerarepair.blogspot.com/2007/11/canon-digital-cameras-showing-black.html

http://www.usa.canon.com/consumer/controller?act=PgComSmModDisplayAct&fcategoryid=225&modelid=13390&keycode=2112&id=29819

Applicable cameras include:
A40, A60, A70, A75, A80, A85, A95, A300, A310, S1 IS, S60, S200, S230, S330, S400, S410, S500, SD100, SD110, IXUS V2/300/400/430/500, IXY Digital 200a/300a/400/450/500

That means that your lcd is starting to go out. Call the repairs dept and see if they will fix it for ya. 800-706-2534 and option 2.