The control panal is displaying weird letters and nothing works.

was dtc codes for possible problem ,

Make sure that the program controller is working if not check power - step down supply, the pads are responding- if not faulty pads- or the door switches, if the switch contact are not good then it will not trigger the processor to switch on the waveguides. If the lights or fan work without any display or action of program being triggered to start then it can be a possible fault on the main board or the processor. Sometimes insect secretion can short the board and display panel and so the processor can work in such an erratic manner. If so clean, solder and reset the board. Now identify the parts by clicking this link: http://www.espares.co.uk/advice/microwave/a/5/141/identifying-microwave-parts.html

I'll thing you'll find the keyboard letters are in the right place :-)

But being serious, you need to change the "regional setting" for the keyboard. If you go into the control panal and select the keyboard settings, you should change it to what you want (I assume UK)

Best of luck

TURN POWER TO THE OVEN OFF AND WAIT FOR 10 MINUTES TURN BACK ON POWER AND RESET MENU.

CHECK THE REFRESH RATE ON TH OLD COMPUTER MONITOR AND MOVE IT TO A HIGHER REFRASH RATE IN THE CONTROL PANAL, MONITOR, PROPERTIES, ADVANCE SETTINGS

ROD

paper jamed reguraly in heater unit

Shut the breaker off to the oven first. Frame around mircowave is a snapped on front. Removing allows access to two screws under control panal. Must actually pull entire unit out about 9 inches to access top of control area to remove access panel. Once front control panel is removed and top is opened, easy access to what you need to get to. Carefully write down color coding of wires before removing any of them. Remove old power supply board and display and reconnect. Reverse process. A bit of work but if you watch the disassembly process carefully, pretty easy.

Why did you buy 8, wouldn't one be good enough?
You've have purchased some defective cameras.
How much did you get them for?

[email protected]

It sounds as if your front panel control is not working. You need to contact a solutions provider in your area for a service call.

For technical assistance by blog, visit our id card printer support at www.safecardid.com/blog.

If the display works, but the machine doesn't fill, wash, or pump out, the control board is the only component that could cause all these symptoms.