An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert who has written 20 answers of more than 400 characters.
An expert who has answered 20 questions.
Re: picture and video camera on my cell
Buy a new one.. the camera must be busted and changing it by your self or by almost anyone could be an almost impossible task since nano technology is so small... how old is that phone? have it ever fallen to the ground?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
restart your camera and going on camera mode. hold the camera button down for few seconds so instead in camera mode,it goes into video mode. take a video and save it you can also take a picture,switch back to the camera mode and test it.
The picture board on your monitor is bad, since it goes
off after few seconds and the power led or button is on, it means the
board of your monitor has developed fault.
The best thing for you
do now is to take the monitor to a local repairer or service center
within your vicinity
to help with the replacement of the picture board
because the fault is not something you can fix yourself, in order not to
Hello, I went and researched a few points in the manual and hope this helps to some extent. If this doesn't help, try resetting your camera by removing the batteries for 30 seconds, then reinstalling them and turning on the camera again.
Monitor is blank: • Camera is off. • Batteries are not correctly inserted or battery-chamber cover is not properly latched. • Batteries are exhausted. • EH-62B AC adapter (available separately) is not properly connected. • Camera is in sleep mode. Press shutter-release button halfway. • Monitor is off. • USB cable is connected. • AV/Video cable is connected
No picture is taken when shutter release button is pressed:
• Camera is in playback mode. • Batteries are exhausted. • Red (!) lamp flickers: flash is charging. • Green (AF) lamp flickers: camera unable to focus. • Message "CARD IS NOT FORMATTED" appears in monitor: memory card is not formatted for use in your camera. • Message "OUT OF MEMORY" appears in monitor: insufficient memory to record picture at current Image mode setting.
well u can turn it on by holding the vlume button for about 2 or 3 seconds. and u can also access the camera, media player and profile settings from the front by holding the camera button for about 2-3 secs.
when u go to ur camera mode try takin ur memory card out see if that solves it failing that reset ur fones memory by going to reset factory settings the pin should be 00000000 or 11111111 any more advice dont hestitate to ask
If the picture taken from digicam are ok when viewed from a computer, the lcd viewer has a loose connection or defective already, if you can open your unit, try to disconnect and reconnect the lcd flexwire inside.