Question about IBM 4224 Model 101 Matrix Printer

1 Answer

IBM 4224 Shuts off after warm up

My IBM 4224 shuts off after warm up....Once it is warm I can't turn it back on until it cools off. Is this the power supply? or is there a fuss that I don't know about?

Posted by on

  • griffjufr Aug 25, 2008

    IBM 4224 Printer G111 does not print, possible bad card. How to get a manual to replace the card?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Hi,

4224 were notorious for poor connections between the control cards and the motherboard. Opening the printer and reseating all the cards solves a multitude of problems. Try it.

Aido

Posted on Mar 06, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

EDITED WITH PICS!!! CENTRAL AIR A.C./HEAT BLOWER FAN DOING OPPOSITE ON/OFF Furnace : H9MPD100J14A3; Control Circuit Board : ST9160B 1050 or HQ1012358HW


Turn power off. Wire nut the Y/G/&R Wires. This should run the blower and outdoor unit with nothing shutting it off but the breaker. Turn power on and monitor for a good 15 minutes. Let us know. ( Yes, this is bypassing the tstat)

Aug 19, 2018 | Heating & Cooling

1 Answer

Shuts off when warm wont stat until cool


audi tt sensors - forum about car parts and car advices

abmforum.com/audi-tt-sensors.html
audi tt sensors 2004 audi tt coupe windows roll down hi all only new to forum 2001 ...2002 audi tt purchase advice newbie looking to get a tt. ... Used on cold starts towarm engine and cat faster. .... replaced and sending my car into limp mode. my ac just shut off one day and will not turn back on. the esp in the car is stuck off.

Sep 22, 2015 | 2002 Audi TT

1 Answer

My 95 ford f150 runs great till it warms up it seems then the fuel pump looses power n shuts down wait few mins kicks back on runs fine till few min later


Sounds like your ignition module it is common on fords to do this when its cool it will start and run fine but once it heats up the truck dies until you let it cool down again and then your up and running till it heats up again. Some modules are mounted on the fender others are mounted with the distributor have it checked and let me know how it went.

Aug 26, 2014 | Cars & Trucks

1 Answer

1999 avenger cuts off when it gets warm


Hi there have you tried the ignition coil as this sounds like the coil is getting hot and creating an open circuit thus no hi tension voltage to the spark plugs,once it has cooled done the car will start again until
it repeatedly gets hot and shuts down very common in pre coil pack vehicles,easy test try a spare coil and drive for same or more distant if not fault them coil is U/S

Feb 05, 2013 | Dodge Avenger Cars & Trucks

1 Answer

What is a 19 error code on the Ibm printer 4224


Attachment Card Failed Power on Tests.
1. Switch Power off (O).
2. Wait 20 seconds and switch power on(I).
3. If the printer displays (19) again then call for service.

May 14, 2012 | IBM 4224 Model 101 Matrix Printer

1 Answer

Car shuts off when it gets hot


your ignition coil are going bad, they need to be replaced. once the car gets hot the circuit shut down the car when hot. once they cool your riding again until they get hot. thats your problem. Good Luck

Jul 31, 2010 | 1988 Buick Electra

1 Answer

Is there a thermostat shut off switch . car runs


The amount that it gets hot is a clue but theres no shut off switch. It's possible that the car is over heating and the temp gauge does'nt have enought water over it to report the problem. once the cooling system is cleared as it's full circulating and the fan will come on when it's hot ( disconnect the temp. switch on the therostate cover on the top of the transmission, ( the stat is in the lower hose ) with it disconnected and the key on the fan should be on and connected f till it's real hot. The crank senser or distrubutor module can can too hot and shut down too

May 13, 2010 | 1997 Toyota Corolla

Not finding what you are looking for?
IBM 4224 Model 101 Matrix Printer Logo

Related Topics:

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top IBM Office Equipment & Supplies Experts

James Cagle
James Cagle

Level 2 Expert

478 Answers

Don  Farrell
Don Farrell

Level 3 Expert

1018 Answers

jasbo
jasbo

Level 3 Expert

2237 Answers

Are you an IBM Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...