Question about Black & Decker Lawn Hog 18-Inch 12 Amp Electric Mulching Mower

1 Answer

Up and down Lawn Mower RPMs

I have a B&D MM675 electric mower. It starts sometimes (sometimes i have to bounce it to get it going) but the RPMs are sporadic never getting to full speed and most of the time stopping after a few seconds. I removed the hood and there seems to be less spark on one side. What do I replace?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 279 Answers

Spounds like a problem with the governor. There should be a spring or something tied to your governor. The governor adjusts your air fuel mixture according to the load. Look closely at all points of connection...Lee

Posted on Sep 14, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Rpms go up and down when I start the car

I would go to Autozone and ask them to check your computer for trouble codes. I would expect a Throttle Position Sensor, or EGR code to be present.

Mar 17, 2014 | 1998 Chevrolet Malibu

1 Answer

Rpms rev but car does not go when gas i pressed then transmission feels like it engages

possible that there is an issue with the torque converter clutch servo/solenoid operation
take it to an accredited service center and have it properly diagnosed

Apr 23, 2017 | 2008 Saturn VUE

1 Answer

I have a 2008 hyosung gt 650r, my rear light flickers and goes out when my rpms go up, over about 5 thousand i would say. When the rpms come down the light is on just fine, any ideas as to whats up with...

The chances are that the problem is caused by vibration, so check your connections and the contact on the back of the bulb holder they sometime get bounced out of alignment.

Feb 18, 2013 | Motorcycles

1 Answer

Two odd electrical problems 90 Ford Bronco 351W

The voltage regulator controls the rate of charge. Also, if you have bad battery connections (including any small wires on the positive post), that can cause your strange symptoms. Check all grounds too.

Dec 08, 2009 | 1990 Ford Bronco

1 Answer

Black&Decker MM675 lawn mower height lever would not stay

I would look in my owners manual and get the part number for the height lever and order a new one. You could also try and wire the height lever so it can not move. I am not sure how it engages but you could may be try and bend the lever so it is tight and won't move. Just a couple of ideas.

Good luck

Aug 31, 2009 | Black & Decker Lawn Hog 18-Inch 12 Amp...

1 Answer

It's eating up the string - what do I do?

Try not to bounce the head unless the rpms rev high. High rpms are a sign that the string is worn short. Bounce the head to dispense more string only when it's obvious you need it. If you tear around bouncing the head on the ground or dragging it (sometimes it's hard not to...) all the time it's going leave two inch pieces of string everywhere because it's being dispensed when not needed. My new Echo was using string up faster than I liked so I tried a small test pack of string with a more aggressive cross section - It worked so well I bought a large roll.

Aug 11, 2009 | Echo Garden

1 Answer

ZyXel P-660HW T1 router - sporadic wireless connection

It could be caused by interference by other nearby networks/devices. Try changing the wireless channel.

Jun 03, 2009 | Zyxel P660HW-D1 Router

1 Answer

Electric mower won't cut well

change a new blade. when was the last time the blade gotten changed?

May 22, 2009 | Black & Decker Lawn Hog 18-Inch 12 Amp...

2 Answers

RPMs bounce around whenever in idle

The throttle position sensor could cause this problem.They are usually easy to replace.

Aug 24, 2008 | 2002 Chrysler PT Cruiser

Not finding what you are looking for?
Black & Decker Lawn Hog 18-Inch 12 Amp Electric Mulching Mower Logo

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top Black & Decker Garden Experts

Nick Olsen

Level 2 Expert

183 Answers

Roland W VanLue
Roland W VanLue

Level 3 Expert

486 Answers

Tim Whalen

Level 3 Expert

3072 Answers

Are you a Black & Decker Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides