Question about Car Audio & Video

Open Question

Ford fiesta 05 stereo wiring diagram

Im fitting the new style ford 6006 cdc in my 02 transit and the wiring is different. here is the fiesta wire colours excluding the speaker wires and i have labeled the ones i think are correct

yellow green - switched 12v
orange/black - constant 12v
thin orangle/black - illumination
black/green - earth
black/yellow - earth
thin grey -
blue -
black -
thin white/black -
brown/yellow -

Posted by on

  • glassic7 Sep 13, 2009

    the five wires at the end are the ones i dont know. thin grey - ? , blue - ?, black - ?, thin white/black - ? and brown/yellow - ?

  • glassic7 Sep 14, 2009

    cancel that i have sourced a wiring diagram.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 35 Answers

SOURCE: How to wire KD-S741R CAR STEREO - WIRE COLOURS ???

older pioneers:

2 x green (1 with black tracer) left rear spkr (black= negative)
2 x white (1 with black tracer) left front speaker
2 x grey (1 with black tracer) right front speaker
2 x purple (1 with black tracer) right rear speaker

Lower connector
1 x red ignition (switched supply)
1 x blue antenna output power (may not be not used)
1 x yellow Illumination (radio button lighting)
1 x orange permanant Battery supply
1 x black vehicle GND

If still not working swap yellow and orange wires! will not cause damage

Posted on Jul 06, 2009

  • 107 Answers

SOURCE: Had to cut wires on ford ka 2003 1.3i to install

they have an instalation kit for your car at autozone or advancedauto.. for less then $15

Posted on Jul 21, 2009

  • 4848 Answers

SOURCE: I have a 1998 ford fiesta and I am trying to

Is this website of any use?

http://www.tehnomagazin.com/Auto-radio-car-connector/FORD-Car-Radio-Wiring-Connector.htm

Posted on Sep 11, 2009

  • 652 Answers

SOURCE: I wrote earlier about the car stereo wiring. the

buy a volt tester and go thru all wires and make sure you test all of them

Posted on Feb 14, 2010

  • 139 Answers

SOURCE: What does the stereo colors stand for on an 1992

Red = ground
black = ground
Grey/blue = Left rear (+)
yellow/black = ignition 12v
white/purple = right rear (-)
green/black = (could this be green / violet?) than it is 12v constant
blue/red = illumination
orange/green = left front (+)
white/green = right front (-)
blue/white = left front (-)
brown/yellow = left rear (tan / yellow) (-)
green/orange = right front (+)
orange/red = right rear (+)
blue = not used

Posted on Nov 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im trying to fit a remote central locking kit to my mk12 fiesta. Could you help with the colour of the wires to join into.


If you have or can get a repair manual, it should have an electrical diagram of the wiring for the locking system on your vehicle. However, if its just a remote locking system for your car doors (I'm assuming that's what this is) then you need only wire it up fitting your current locking system. You will have Power (Red), Source (Yellow), ground (black) and if like a stereo system you'll need a "remote wire" which is a smaller Blue wire which would connect to the ignition IF you have auto locking doors after you put your vehicle into drive and they lock after so much time 10-15 sec or so. If not, there should be no remote wire needed.

Dec 11, 2014 | 2007 Ford Fiesta 1.4

2 Answers

I need to know the stereo wiring for a 1998 ford windstar. im trying to put in a new and i dont know what wires to match it up with


here you go...
1998 Ford Windstar Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Green/Violet
Car Radio Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black/Light Green
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Dark Green/Orange
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Light Brown/White
Left Rear Speaker Negative Wire (-): Light Brown/Yellow
Right Rear Speaker Positive Wire (+): Light Brown/Green
Right Rear Speaker Negative Wire (-): Brown/Pink

Oct 16, 2010 | 1998 Ford Windstar

1 Answer

Hi im after a ignition wiring diagram for a 1989


1989 ford transit ,with a york 2.4 diesel engine a real white van man motor ,knocks any american big bore gas guzzling CO2 emmiting junk into shame .right what do want too know

Aug 02, 2010 | 1989 Ford Aerostar Cargo

1 Answer

Ford radio 6006 CDC, fitted in Fiesta ST, fault discharge battery


Was wondering if anyone can help got a Cdc error on the stereo 6006? Also wondered how to load the cds into the stereo?

Apr 24, 2010 | Car Audio & Video

1 Answer

Wiring diagram for jvc model no ks-fx460r


http://books.jvc.com/booklist.asp?Model=+ks-fx460r this should take you to the down loadable manual for that head unit.

Jan 12, 2010 | Car Audio & Video

1 Answer

I need a wiring diagram for the aiwa stereo harness.


I would like to see a plug for a aiwa car stereo

Mar 30, 2009 | Aiwa CDC-X207 CD Player

1 Answer

Having problems fitting Panasonic CQ-C1323NW car stereo into Ford Fiesta


YOU SHOULD HAVE TWO LEADS IN THE CAR, ONE FOR POWER AND ONE FOR SPEAKERS, YOU WILL NEED A FORD TO ISO ADAPTOR LEAD AND THEN YOU WILL NEED THE LEAD WHICH CONNECTS TO THE PANASONIC RADIO

Dec 05, 2007 | Car Audio & Video

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

992 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4848 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

The Knight
The Knight

Level 3 Expert

74118 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...