My hp 1210 all in one stopped copying before it was printing but lower half of lines was coming faded now it stopped working it takes paper&send it out plain

Printing or paper?.. If printing check 1. check with another cartridge 2. check half test page(half test page while printing half page stop printer remove cartridge & paper see the image created on cartridge drum or not ,if not clean the Laser scanner assm, check on paper proper image or not if not clean the transfer roller.(looked like sponge roller located just under the cartridge location). beyond this trouble shoot, advised to send it to service center..

This problem is mainly due to driver corruption
1. Reinstall the driver or scan for viruses and remove it.
2. Remove all temp files from the drive.
3. Try removing corruption in OS or reload OS.
4. Try connecting to another system and take print out.
5. Chipset on the printer may be having problem, get it serviced.

there are 2 cartridges in for this printer, have you tried replacing both cartridges with new ones?

If yes then your printer needs some maintenance too

This video should help.

try to scan and save the document intoa ile folder

I assume you had the issue before you changed the toner, If so the problem is either the fuser or the Laser.
Do this:
start a print job and after you hear the paper feed into the machine open the top cover to stop the machine. You want to stop the page before it gets to the fuser. May take a couple tries.
remove the toner cart.
the page should be under the cart with the image on it.
If the line is on the page the problem is image development(toner or laser).
If no lines the problem is likely the fusing assm.

Check the paper size setting in the software and print driver. Sounds like a non-standard paper size setting.

check the wright cartridge model you installed and well pluged to the printer

if it is ok

try to change printer properties and fix it correct options with there tabs ( ex: paper, print quality etc)

all are well try to reinstall the printer driver

Are you sure that your scanner bulb is working. You may hear the scanner moving but the bulb may be burned out which will cause you to get blank pages.

Inkworks

Hi,

Please check the printer status at control panel printer properties if it is offline or ready. Restart your computer if necessary, you will notice all pending jobs will be printed as long as there is no problem with the connections of cables and drivers. Note: Do not cancel printing jobs in the middle of sending data mode to printer or queing instead you have to remove all papers on tray and wait for the error "paper out or empty" then there click Cancel. Hopes this helps.

Best regards,
Rosener Guyano