Mouse not clickking

This could be either mechanical or software. Try the right mouse click...does it work?
Try another external USB mouse. If a known working mouse doesn't work, your computer may have a virus preventing you from clicking.Else, your mouse has a broken or dirty switch.

Mine would work fine until I turned on my wireless headphones...then the mouse would move a little stop.....move a little....then stop.

I made sure my headphones were on.

I turned off the mouse, moved the mouse reciver to a USB port on the front of my computer (the mouse reciver and the headphone receivers were next to each other on the back of the computer). I turned the mouse back on.

The computer imediately gave me the "installing USB driver" notification.

When it was complete....both played nicely together...no more problems.

re-install mouse drivers or replace mouse port

check the tension of the spokes.a loose or not properly tensioned spoke can cause clicking.also check the tyre valve screw.if it isnt screwed tight enough you get a click as the tyre moves round

Hi,
please find some button near the mousepad. this is used to disable and enable the mouse arrow.. You might have accidentally clicked the button which disable your mouse.. so click it again to enable the mouse pointer.

I hope this is helpful to you.
Thanks

In my mind it's just a couple things. The mouse or the port. Hopefully you haven't removed(or plugged in) the mouse plug when the laptop was turned on. [Only a USB can be plugged/unplugged when the computer is on.]
Try getting a new mouse. If that doesn't work you may have to have it taken in and have it looked at. Good luck.

Yes open the mouse and clean the left click that should help if not is time to buy new mouse

There's also a connect button on the USB connector. Plug the connector in and press the connect button underneath until the light flashes. Release the button and click the connect button on the mouse until the USB light is steady.

have you checked that it is the USB port if it is not in the USB port it will not respond

The BenQ M310 mouse needs to "sync" with the USB receiver. Need to push the two buttons at the same time, or maybe the one in the mouse first then push the button in the USB receive so the two can "sync" to each other. This may solve this problem. Good luck!