Question about VIA ASRock K7VM3 Socket A/ KM266PRO/FSB333/DDR333/A&V&L/Modem/MATX MotherBoard (MOTASR09)

1 Answer

Suddenly Freeze I have been using more than 2 years comfortably but now sometimes freeze without warning. Reset switch does not reset in this condition. I have to power off then power up. Sometims this also does not start. No seek for hard disk, floopy disk nor CD drive. No bios screen comes up and totally blank screen. Power of little while and sometimes it comes back. I suspect the Power supply or CPU temp or RAM. Where can I get a temperature monitor software for this motherboard model? I am using Athlon xp 2000+ cpu.

Posted by on

Ad

1 Answer

End

Posted on Dec 10, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Samsung dvr 7162 need to reset password


please help me to reset password Samsung DVR SHR7162

Dec 24, 2012 | Samsung Shr-7162-15t Dvr Shr7162 Techwin...

1 Answer

GAME WILL LOAD BUT FREEZE MINUTES AFTER LOADING


try doing a factory reset but be warned resetting it deletes all data and restores it back to factory default this should correct the software glich that is causing your ps3 to freez or lock up

1. Power Off the PS3 via the power switch in back and power back on w/switch.

2. Hold Power Button on the Front until you hear 3 beeps.

3. Then go through the initial setup and then run a full Format via System > Format.. You may need to have our AV cables ready if your using HDMI (in case HDMI isn’t detected after initial reset

Jul 31, 2009 | Sony Playstation 3 (PS3) Console

1 Answer

DVD/HDD machine freezes and needs to be reset each time it's used


yes there is .......u can reset to factory setting.....u will find it in ur Manuel booklet/////
if not go in touch with daewoo service depaartment and u will get help from them
cheers hope all works out for u.......

Jul 03, 2009 | Daewoo DVG-8500N DVD Player

2 Answers

My compressor will not start.


There are a few more things to try, in the control unit of the AC there is Cold Control/Freeze Switch. Take down the control unit (inside unit, remove inner shroud) and remove the cover, The freeze control is plugged into the blue plug on the board. Remove the plug and install a jumper wire in its place. Does the compressor come on? If so, you have a bad freeze control. If not, then we need to check and see if your AC power module is sending power to the Compressor. Check power across the relay in the control unit, Black to Blue. If the blue wire is hot, then you need to go upstairs to the top of the compressor and check the thermal overload. If the blue wire is not hot, the comfort control center may not be sending a signal to turn the compressor on. If it is not, do a reset of the CCC. For a five button system, turn the tstat off and hold down the Mode and Zone buttons simultaneously. While holding them down, turn the CCC on and hold the buttons until FF appears on the screen. Release the buttons and try the AC.
Four button reset -
Depress MODE switch to activate annunciator light.
Simultaneously depress the bottom two buttons
(temperature UP and DOWN) and hold.
While holding these buttons down, depress the
MODE button once and release.
Release the two buttons previously held down.
Depress the MODE button once again.
At this time the light should extinguish, and the mode
should register “OFF”. If not, repeat Steps 2 through
6.
Retest system ensuring that all functions are present
and operational.

Hope this helps,

Jeff

Rate me please!!

Jun 28, 2009 | Dometic 57915531 Air Conditioner

1 Answer

I get F4 (Freeze control failure) on my Dometic Penguin A/C


This is from the service manual:

16. SYSTEM RESET
a. Turn the ON/OFF switch to .OFF. position.
b. Simultaneously depress and hold the MODE and ZONE
push-buttons while turning the ON/OFF switch to .ON..
FF should appear in the LCD display until the MODE
and ZONE push-buttons are released.
c. When a dip switch is turned on or off after initial configu
ration, a system reset will need to be done before the
Comfort Control CenterTM will recognize the updated selection

Hope this helps

Feb 28, 2009 | Dometic Rooftop RV Air Conditioner

1 Answer

Computer freezing- blank white screen


Check your connecting cables to the monitor. They can become loose or you may have a cracked cable.

Jul 13, 2008 | HP Computers & Internet

Not finding what you are looking for?
VIA ASRock K7VM3 Socket A/ KM266PRO/FSB333/DDR333/A&V&L/Modem/MATX MotherBoard (MOTASR09) Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top VIA Computers & Internet Experts

David
David

Level 3 Expert

781 Answers

Abhinandan  Patil
Abhinandan Patil

Level 3 Expert

569 Answers

jason

Level 3 Expert

905 Answers

Are you a VIA Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...