Question about Washing Machines
Clean out the filter, also clean out the outlet hose. Power off the machine at the mains for 15 mins and then switch cback on. If you still get the problem than you most likely need a new water pump. If this is so then call your repair man.
Posted on Sep 10, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Error E20 means the machine has failed to pump out. 1st check the filter at the bottom right hand side there may still be water inside if so pull the grey tab to the left of the filter there should be a thin hose extend it put it into a shallow dish and pull the cap off to let the water drain this may be a slow process. When the filters out look into the hole with a torch to see if any obstructions in the pump impeller this looks like a cross. If the filters and pump are clear it may be the pump has failed.
Posted on Dec 17, 2008
E20 is "A problem with water draining"
The drain hose may be squashed or kinked
the drain pump may be blocked
or possible your filter is totally blocked. Clean out the filter everything will work again. Put a large bowl under the filter as you unscrew it; a fair amount of water could be there.
Good luck.Please rate the solution if accepted, also do post comments in case of any doubts.
Posted on Jan 23, 2009
SOURCE: ZANUSSI WASHING MACHINE
seems to be a problem with the filter. was with mine.. one thing i always forget to clean it regularly.
Be careful when open the little hatch thingie , there will be water coming out . so prepare with a bakingtray and kitchen towels. and open it SLOWLY!!! so the water doesnt totally soak the floor.
then clean clogged up filter. at least that solved the problem in my case, hope it works
Posted on Dec 29, 2007
This error code seems to be the control board detecting a wrong
configuration (in other words, an illogical set of sensing conditions,
from its connected sensors and wiring). It apparently can happen, when
wires become badly contacting, or if contaminated with motor brush
carbon (the horrible black powder that comes off the motor commutator
and brushes), or corroded from other contaminants from the soap
dispenser area. You should be able to check this, remove, clean and
replace the contacts:
Posted on Jul 01, 2009
Tips for a great answer:
Jan 26, 2016 | Washing Machines
Feb 09, 2015 | Zanussi Washing Machines
May 19, 2010 | Zanussi FJS1225W Front Load Washer
Oct 18, 2009 | Washing Machines
Jun 06, 2009 | Zanussi ZWD1470W Front Load Washer / Dryer
Feb 21, 2009 | Zanussi ZWD1480W Front Load Washer / Dryer
Jun 19, 2007 | Zanussi FJS1225W Front Load Washer
Sep 26, 2006 | Zanussi ZWF1430W Front Load Washer
2,070 people viewed this question
Usually answered in minutes!