Question about Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer

1 Answer

Putting fuel line on right on ryobi 725r 15'' 31cc weedeater

I have a ryobi 725r 15'' 31cc an i need info on how to put the fuel line back on right!! If you have a pic of the right way that would be great thanks Ernest.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,776 Answers

Typical fuel line routing is:

One line (the one with the fuel filter in the end of it) comes out of the fuel tankputting fuel line on right on ryobi 725r 15'' 31cc - 2.gif and goes to the bottom fitting on the carburator. The second line comes out of the tank and goes to the bottom fitting on the primer bulb. The third section of line goes from the top fitting on primer bulb to top fitting on the carburator. Hope this helped and best wishes.

Posted on Sep 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Weedeater 380


Hi Nick, Ryobi Weedeaters are all two stroke. They need a fuel to oil mix of about 40:1. This is why they dont have anywhere to put oil in. It goes with the fuel.

Jul 23, 2013 | Garden

1 Answer

Ryobi 705R weedeater won't run. I can get it to


Yes, it is possible. Here are a couple of Tips to remedy your problem:
www.fixya.com/support/r6078121-fuel_line_relacement_trimmer_weedeater

This should get it running for ya.

Good Luck!

Jim

Jul 24, 2011 | Tools & Hardware - Others

2 Answers

Ratio for oil and gas on a ryobio weedeater


if you are using stihl oil the ratio is 50:1

Jul 03, 2010 | Ryobi Three Trimmer Combo

1 Answer

Gas line cracked and nipple fell back into tank ..how do I remove gas tank to replace gas line and nipple????..ryobi 725r trimmer


Empty the tank by dumping into a can or something. Shake the trimmer around until the "nipple" falls out. Get a replacement fuel line and follow their instructions. When yoou put the tube back into the tank, have something that you can guide the line through the hole with. I used a small hex wrench. If you cut the tip of the tube at a sharp taper, it will be much easier to start through the hole. You might think of replacing the return line as well. You should not have to remove the tank if you expose the carb and remove the air filter...Good luck...Lee

Aug 02, 2009 | Ryobi Garden

1 Answer

RYOBI weed eater.hard to start. starts then stops


I have a ryobi doule line bought in 1997..Had same problem put new gas cap on and problem solved..could not get air in....

Aug 01, 2009 | Ryobi Garden

2 Answers

How to remove drum connector off ryobi weedeater


I believe there are four phillips headed bolts around the outside edge of the housing

Jul 23, 2009 | Ryobi Garden

2 Answers

RYOBI 725R FUEL LINE DIAGRAM


I just rebuilt my 725r. I don't have a diagram but I can explain it. There are two lines coming out of the fuel tank. The line closest to the rear is the fuel feed and has the in-tank filter (these are available for replacement). This line goes through the lower case hole of the air filter housing and attaches to the bottom of the carburetor. The line toward the front of the tank attaches to the longer/lower fitting the primer bulb and is the return. The line coming off the shorter/upper fitting of the primer bulb goes through the upper hole of the air filter housing and attaches to the top of the carburetor.

FYI also, the forward carburetor screw is the low idle adjustment & the rear, the high-speed mixture. The original oil mixture spec called for 32:1

Jun 13, 2009 | Ryobi 15" Electric Factory Reconditioned...

1 Answer

Need routing of fuel lines on Ryobi string trimmer Model 725R.


The larger fuel line goes from fuel filter to carbuerator.The smaller line is the return line from the purge bulb tofuel tank. mitchjl_1692

May 27, 2009 | Ryobi 15" Electric Factory Reconditioned...

1 Answer

How do you thread a Ryobi 725R Weedeater


Hi,
If you still have problems withe line spool,try changing it to this after market head,I changed mine and it works great!
http://www.lowes.com/lowes/lkn?action=productDetail&productId=120473-42694-14548&lpage=none&cm_mmc=search_yssp-_-Unassigned-_-060209-_-Shakespeare%20Universal%20Fixed%20Line%20Trimmer%20Head

Apr 06, 2009 | Garden

4 Answers

Ryobi 2 cycle gas trimmer 705r/725r


The gas nipple that come out I have...whats goes in the other hole?

Aug 28, 2008 | Ryobi Garden

Not finding what you are looking for?
Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer Logo

2,268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ryobi Garden Experts

Nick Olsen

Level 2 Expert

183 Answers

Rexter1

Level 2 Expert

40 Answers

Roland W VanLue
Roland W VanLue

Level 3 Expert

486 Answers

Are you a Ryobi Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...