An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has written 20 answers of more than 400 characters.
Re: earpice simble shown always
The headphone pin has got kicked in due to your constant headphone jack in and out need to diaasemble the piece and refit the headfone pin jack of the piece or temporarily just put your headset in and then in a sudden thrust pull it out that should do the trick of pulling out your headphone jack, thus no headset symbol and voice thru earpiece.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Sounds like you have a computer sound issue. If the waveform is shown, and the amplitude is sufficient then it should playback audio. Not familiar with Mac but check mute settings, sound card volume, input/output config., audio routing, etc.
I suspect that you actually have the Koss multimedia headphone/microphone model SB/45 as shown on the right earcup, not SB145.
If this is the case, the 3.5mm connector with the black plastic (contains a headphone symbol molded into the plastic) and red insulation bands separating the conductors is for the stereo headphones. The other 3.5mm connector with the tan plastic (contains a microphone symbol molded into the plastic) and black insulation bands is for the microphone.
You need to plug these into the microphone input and headphone output connectors on your computer or whatever device you are recording with. Then adjust the microphone input audio level and headphone output audio level on your recording device. Consult your manual for your recording device to locate the correct connectors and for instructions to adjust the audio levels.
Also, be sure to check and adjust the volume level control on the headphone cord if you don't hear anything after correctly connecting them to your recording device and adjusting the levels.
If you can not hear the person at the other end, it means your phone has a hardware problem. The earpice of your phone is bad.
Swiych of the phone. Remove the battery. Get a screw driver, loose the screw and open the phone.
Gently remove the earpice and take it to the phone accesories store to get a replacement. Replace the new earpice with the old one and couple the phone.
Put your battery and switch on the phone and start making calls.
No it does not have a built in microphone, but it does have a microphone jack next to your headphone jack on the right side of your laptop. You will have to buy a microphone for your computer, sorry for the bad news, but at least microphones are not that expensive. Especially if you just want it for skype then you can just buy the cheapest one possible and be fien.
Try opening the volume control (you should find a VOLUME icon in the bottom right corner of the screen. Right click on this and open volume control. Check if the "microphone" level is down or if the mute button is checked. If it is, click on it again to uncheck and increase the microphone level to full. If you do not see the Microphone level at all, click on "options" and then "properties" and make sure microphone is checked.