Ronning motor cc/5440m12

Non detergent 30w mineral or synthetic

Should be just fine!
Any smaller, however, you might find the motor is laboring to run the compressor, as the motor may have been factory matched.
Be blessed.

Pressure switch may be stuck. May need to adjust pressure switch.

You can get the manual for model 41214 from my dropbox area:

http://dl.dropbox.com/u/54567653/husky_aircompressor_model_41214.pdf

BTW, if you find this manual helpful consider installing dropbox using this link (full disclosure -- I do get about 0.2 GB freespace from dropbox if you install using this link):
http://db.tt/vQycqXIW

Thanks,K

Any good auto parts store can help you ...

The pressure switch controls the motor on and off. Adjust the pressure switch up to increased the 'off' setting for higher pressure.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

Compressors pull a lot of juice that is why they come with a large power cord. If you use a small extension cord with it it will easily pop a breaker. So first check all your breakers. Second thing is check your manual to see if you have a reset switch on you compressor, as most do. It should be a small, red switch (rocker or push button type), located between the pump motor and compressor switch. The third is a long shot, check to see if the bleeder valve is functioning correctly. It will be the small copper tube running from the pump to the switch. Just make sure the small lever is free to move.

If this fails to resolve the problem then it is probably the main switch itself. That is a warranty issue. If it's out of warranty then your going to have to either repair or replace the switch yourself. Please feel free to ask for help if you need it in latter case.

hi! there,
you can use terminal connector like on figures joint connector or lug connector
this are more convenient to use
easy to install and has insulated for connection.



insulated ring terminal connector
this is also good for connector more safe for circuit breaker suipply.

go to the nearest hardware or mall

I think I can help you guys needing a replacement CC-5440M12 120V/60Hz Ronning Motor. I have been cleaning out my shop and I have four (4) of these used electric motors. All work fine. They still have the plastic fan blade on one end and the metal gear on the other. I actually have electric cords wired up on each of them that I used to make sure they worked.
Thought I would pass this information on to you. Thanks and have a great day.