Question about Toys

1 Answer

I have installed a Graco car seat into a 2002 Hyndai Elantra. On the top of the rear seat there are car seat anchors. The Graco instructions do not address any connection to the anchor. How is this to be used in the installation of child car seats?

Posted by on

  • eseelman55 Sep 04, 2009

    Is the belt, in your picture, that is with the attached to the anchor supposed to be supplied with the car seat or does it have to be purchased seperately?

  • eseelman55 Sep 04, 2009

    Your comments have been very helpful. I will be in contact with Graco about the belt, but there is no reference to a belt or even attaching the seat to the anchor in the car. Thank you very much for the information.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 5,158 Answers

There are sometimes hooks on the rear dash panel. but often as i had to do with one car you have to drill the holes to hold the anchors in.

i've attached a picture to show you how they would attach. if you need a picture of the actual anchor let me know.
I have installed a Graco - 92ee3d2.jpg
robert

Posted on Sep 04, 2009

  • Roberta Smith
    Roberta Smith Sep 04, 2009

    there should have been a belt with the seat. the one shown is somewhat different then i have seen before in that it appears to be a double strap. if there is no belt contact graco or the store that sold you the seat as that is a serious error they would have made.



    as a side note after you have installed the seat stop by the local police dept or health unit and they will inspect the installation for you. i have a few police friends and they've told me they would rather look them over now then to investigate an accident that involved a child in an improperly installed seat.



    robert

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my SureRide convertible car seat, the ******** the anchor hooks is to short and the latches will not reach both anchors in my car. I have moved the rear facing seat from the middle of the car to o


I would suggest reading the user manual for the Evenflo SureRide convertivble car seat, which is available here:http://www.evenflo.com/Portals/0/instructions/Inst-SureRide-T65-0911.pdfAnd be sure to contact Evenflo. They can provide the best help for your problem:http://www.evenflo.com/corporate.aspx?id=175
Also, these how-to installation videos may be helpful:
http://www.evenflo.com/support.aspx?id=494

http://www.evenflo.com/support.aspx?id=492

http://www.evenflo.com/support.aspx?id=493

Feb 12, 2013 | Evenflo Symphony Convertible Car Seat ...

1 Answer

I washed my daughters graco car seat and now i havent a clue of how to put it back together and i need re assemble it fast please help


Proper installation of a car seat is imperative to protectan infant. Accidents do happen and assuring that the instructions forinstallation of the Graco Infant Restraint/Carrier are followed will increasethe chances of preventing injury or death as a result of an accident. Graco carseats are a popular choice among parents due the availability of products atcommon retail stores, affordability and user-friendly baby gear.Graco Car SeatInstallation
Step 1
Plan to secure the infant seat facing the rear inthe middle of the back seat. If a center position is not available, positionthe seat directly behind the driver's side seat. For safety reasons, therestraint should not be placed in a position where there is an air bag. Ensurethat the proper vehicle lap belt system is in place; manually adjusted lapbelts, automatic locking retractor lap belts and lap/shoulder belts withlocking latch plates are all considered safe for use with the Graco InfantCarrier/Restraint.Step 2
Remove the carrier from the Graco car seat baseby squeezing the lever at the rear of the restraint and lifting the seat up.Place the base in the vehicle facing the rear. Thread the vehicle shoulder andlap belts through openings at the end of the base without twisting the belts.Secure the belts by placing plastic tongue over the belts. Tighten the vehiclebelts by pushing down on the base and pulling out any slack.Step 3Install locking clip to secure shoulder and lapbelt together just above the seat belt buckle. Connect the two belts with thelocking clip. Buckle the lap belt system and tighten by pulling out any slack.Ensure that car seat base is secure by pulling and pushing on it; the baseshould not move sideways, forward or backward.Step 4
Place the Graco carrier in the base. Push down onthe restraint until it clicks and locks into the base. Set the infant in therestraint for travel and place harness straps over the baby's shoulders. Clickthe chest place together over the sternum and lock the buckles into placebetween the legs.Tipsand Warnings
  • Contact local police departments, hospitals and fire departments to inquire about child car seat safety checks
  • Graco Infant Restraint/Carrier will not protect against serious injury or death if not installed properly. Always read the Graco owner's manual that comes with product prior to attempting installation and travel with an infant.

Jul 19, 2011 | Home

1 Answer

Install graco snugride to a graco stroller


Fitting your Graco Snug Ride infant seat into a Graco stroller is usually easy to do -- the exact instructions just depend on which stroller you have. Typically, all you have to do is fold the stroller's canopy back, recline the seat (if it reclines), and snap the car seat in (backwards -- facing the rear of the stroller). You can hear it lock in place when it's in correctly. Your stroller's manual will have specific instructions, and if you don't have the manual you can find it online.

Which Graco stroller do you have?

Nov 24, 2009 | Graco Snugride

1 Answer

My graco centery carseat doesnt' feel tight in the car and wants to tip sideways around a corner. i have it in with the type of seatbelt that you pull from above?


you must also use the belt provided at the top back of the carseat to anchor it to a welded hook provided in your vehicle either at the bottom on the back of your rear seat or in your trunk

Aug 05, 2009 | Graco Century STE44164

2 Answers

Need to find a better place for a 1000 watt amp.


wait a minute, so do you have the subwoofers installed already?
If so, I would say just lay somewhere around in the trunk lol.
I have a 1998 Hyndai Elantra and that is my set up.

Apr 09, 2009 | Car Audio & Video

1 Answer

How to install graco seat in 99 jimmy


i think the snug rides are rear facing only. if it pulls out of a base and has a carrying handle. its rear facing only.

Mar 02, 2008 | Graco SnugRide - Clover

4 Answers

Shoulder straps


You can contact EvenFlo directly, they will be happy to help you out: http://www.evenflo.com/ Evenflo ParentLink Department: 1-800-233-5921

Mar 31, 2007 | Evenflo Aura Traditions Travel System...

Not finding what you are looking for?
Toys Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toys Experts

kakima

Level 3 Expert

102366 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

16099 Answers

Are you a Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...