Hayward H Series Induced Draft Abg 100,000 Heater Logo
Posted on Sep 02, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Will not light , worked the night before, next morning I turn on,fan starts, it clicks, I smell gas but it does not light, I wait 30 secs. and it clicks again, still does not light.

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

New Friend:

An expert that has 1 follower.

  • Expert 139 Answers
  • Posted on Sep 02, 2009
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Governor:

An expert whose answer got voted for 20 times.

New Friend:

An expert that has 1 follower.

Joined: Jun 19, 2009
Answers
139
Questions
0
Helped
82598
Points
223

Since unit is calling for heat,i would suspect a faulty ignitor.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

I have a 2000 Nissan frontier crew cab 2wd 3.3 motor with automatic,in the mornings I will warm it up and when I put it in drive I have to wait from 30 to 45 seconds to a minute before it goes in gear

please check fluid level again

use this technique please
DRIVE FOR 15-30 MINUTES TO WARM UP TRANNY
1 find FLAT GROUND
2START ENGINE WITH FOOT ON BRAKE

3 PUT IT INTO DRIV- WAIT15 SECONDS

SHIFT INTO EVERY GEAR AND LEAVE FOR 15 SEC-30 SEC BEFORE NEXT GEAR

RETURN TO PARK

CHECK FLUID LEVEL- ADD AS NEEDED- IT SHOULD NOT SMELL BURNT if this happens in every gear while driving, may be torque converter- take to good tranny shop for inspection- happy trails
0helpful
1answer

Power led light on when pressing power it tuns on and goes of right away? power still lit..

I have the same problem, did you figure out what the problem is and solution by any chance? i purchased it recently, it started doing this the night after i left it on for the night. next day everytime i turn on, it turns off in 2 sec. after a month i tried a shot, it started and stayed up for 1 min may be... then same thing again 2 sec. i guess i have to wait for a year to turn it on .
garden led light
0helpful
1answer

ASUS P5N-E SLI motherboard gives 10-15 sec bleeps at 0135 each morning. This sudenly started to ocure 4 nights ago.

Motherboards have a "timed-wake-up" option.
You can enter BIOS SETUP, and configure the computer to wake-up at a specified time, e.g., 01:35, on specific days, e.g., "daily".

Restart your computer.
Enter BIOS SETUP
Set the computer's clock to 01:30.
Save the setting
Exit from BIOS SETUP.
Turn the computer off.
Wait 5 minutes, until the computer's clock advances from 01:30 to 01:35, and watch what happens.
1helpful
1answer

Car starts great in morning smell gas little bit after warms up takes a bit to start rpm go up and down for 30 sec

i would try replacing the throttle position sensor its located on the side of your throttle body

hope this helps
0helpful
1answer

Freezer not working but refrigerator is...I smelled wires getting hot and unplugged the whole unit and waited about 30 minutes then plugged it back in and noticed the next morning that the refrigerator was...

refrigerator can not work unless freezer does / as the ref get's it cold form the freezer in 99 % of all f-ref units . so the burning smell may have been the def heater's look for frost build in back of freezer and possible a evap fan failure . / make sure the fan in freezer is woking .. mm
0helpful
2answers

Can't re-light the pilot light

THIS HEATER DO NOT HAVE A PILOT YOU MUST HAVE A DIFFERENT MODEL. DO YOU GAS? TURN KNOB TO PILOT PRESS. LIGTH PILOT WAIT FOR 60 SEC AND RELEASE IF STAY ON TURN KNOB TO ON. IF TURN OFF PILOT MUST BE REPLACE
0helpful
2answers

SAMSUNG HT-X50

Do you smell anything burning. This happened to me and I cut it back on. It stayed on for 30 secs or so and did the same thing. After doing this 2-3 times, I smelled a burning. Being a member of the Fire Dept, I didn't want to see my buddy's coming to the house, so I unplugged it. The next day, I took it apart and there was a burnt resistor or something under neath the fan. I took it back and they gave me a new receiver, but I'm expecting the same with this one.
Not finding what you are looking for?

159 views

Ask a Question

Usually answered in minutes!

Top Hayward Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29494 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Hayward Pool and Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...