Question about Konica Minolta magicolor 2430 DL Laser Printer

1 Answer

All four toners are saying that they are not installed

I tried new cartidges still no luck. Clean the contacts on the chips and what reads the chips. What is up?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has answered 200 questions.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 214 Answers
Re: All four toners are saying that they are not...

Take out the chip reading contacts and cleant it with alcohol and air then put it back, shuld work. Toners are originals or refilled ?

Posted on Dec 07, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Brother dcp 130 keeps saying no black ink even though i,m after installing two new cartidges

make certain that contacts on new cartridge and on printer are clean so computer can read replacement cartridge.good luck

Feb 17, 2012 | Brother DCP 130C All-In-One InkJet Printer

2 Answers

Clx 3175 samsung invalid toner

here's my solution, in one solution i read about, it mentioned contacts possibly being dirty, so I checked the contacts at the back of my new cartridge but they were really clean and shiny. So I checked what the contacts on the back of the old cartridge look like and I couldnt see them, it looked like someone had put a piece of card over them, so I thought what the heck, I'll cover the four contacts on the back of the new one with some sticky worked! No probs since!

May 23, 2011 | Printers & Copiers

2 Answers

I keep getting a message on the printer saying install C TnrCart Ive repeated the process twice and installed a new toner but it keeps saying it?

Epson C1100 toner detection is based on freq. your chip on the toner might be old or faulty.
The toner does not have contact point.. at the right side of the printer, there is a receiver, and at the side of the toner, there is a round chip..

Apr 07, 2010 | Epson Aculaser C1100 Printer

2 Answers

Canon ImageClass MF 6550 Error Toner Low- Prepare New Toner

There are two contact on the right wall off the printer cartridge chamber area. They can get pushed in causing the printer cartridge to not read correctly. Take a small Flathead screwdriver and bend them up so the cartridge ink level can be read.

Dec 17, 2008 | Canon imageCLASS MF6530 Monochrome Laser...

2 Answers

How to install toner chip on epson c1100

The toner chip is situated on the end of the toner cartidge - it's a circle, about 1.5cm in diameter.
They may have given you a new housing, in case you damage the one currently on your toner, when you try to remove it.

Nov 15, 2008 | Epson Aculaser C1100 Printer

1 Answer

Minolta 2400W - Put cyan / black toner

hey, the problem is that toner cartridge reading chip is dirty.
take out Pc drum and remove all toners, clean toner chips with alcohol. then locate a 3 pin reading chip under the toner rack left side and use pressure air to clean it. reinstall everything. if its not helping, replace the chip, its not expencive

Jun 28, 2008 | Konica Minolta magicolor 2400 Laser...

3 Answers

Toner Not Installed - After replace black

pleas clean toner chip reader, remove pc drum and all toners, under the toner rack there is a 3 pin chip reader, use pressure air to clean it. if the new BK toner is not original, it will say only not genuine toner but will print.

Jun 23, 2008 | Konica Minolta magicolor 2400 Laser...

2 Answers

Konica minolta 2400w toners problem

My Konica 2430DL does this every time I start the printer, I am quite sure it is supposed to do this as I it rotating the toner and calibrating itself. On one occasion I recently had the status monitor say to install cartridge... I removed it, shook it, reinstalled it with the same results. I just purchased a new Konica brand toner, replacing the old one and 'voila' sucess! It still does the little dance (rotation) every time, but it always has, but after installing the new toner the message went away. If you reinstalled the toners, this may be your problem - you need all new toners; spendy but it should solve your problem, otherwise; if you've already done this, I don't have an answer. Good Luck!

Dec 28, 2007 | Konica Minolta magicolor 2430 DL Laser...

Not finding what you are looking for?
Konica Minolta magicolor 2430 DL Laser Printer Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Konica Minolta Printers & Copiers Experts

Norman  J Weimar Jr
Norman J Weimar Jr

Level 3 Expert

5693 Answers

David Burkhart
David Burkhart

Level 2 Expert

207 Answers

George Mclaughlin

Level 2 Expert

330 Answers

Are you a Konica Minolta Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides