I've ordered a blue ray disc from kalahari, but it won't play on my player. it says mismatch between disc and unit region code

The laser mechanism has lost its ability to focus properly. Not cost effective to repair. Get a new one.

follow this steps and fix it. God bless you

Does not play disc

1. No disc. - Load a disc into the tray.
2. Disc has been loaded upside down. Place the disc with the label side up.
3. Disc region code does not match region code of the player.
4. Disc type is not the correct type to play.
5. Disc is damaged or dirty. Clean the disc or try another.
6. Moisture may be condensed inside the unit. Remove the disc and the leave the power on for one or two hours.

With your set on and without disc in the tray:

1. Press PLAY from your remote control
2. Press the following button sequence: 1590 2379 390
3. Press PLAY again

This will release the region verification in your player(region free). However, some DVDs (multi region in particular) will not play, since they require region detection from the player unit.

Does not play disc
1.No disc. - Load a disc into the tray.
2.Disc has been loaded upside down. Place the disc with the label side up.
3.Disc region code does not match region code of the player.
4.Disc type is not the correct type to play.
5.Disc is damaged or dirty. Clean the disc or try another.
6.Moisture may be condensed inside the unit. Remove the disc and the leave the power on for one or two hours.
Use the owner manual for additional information.
God bless you

works on the BDP 2700 -
turn on player without disc. push home button(looks like a house) on remote. enter 1389310 using remote. wait 10 sec then turn off at front of player. wait 10 sec then turn on at front of player.

I believe the 7200 is not able to be unlocked for region free play though

Every blu ray or dvd player sold in the world comes as standard unlocked to play any disc from any region. On the fifth play of a disc the DVD or Bluray will become locked to that region. So if you play 5 USA dvd's on the player after the fifth disc has been played only US dvd's will be recognised by the player, Same applies to BLUrays. So if i were you i would be careful about what discs you are putting in the player. Otherwise you will be left with a bluray player that cannot be used in Australia. After that happens the only way to play other region discs would be to get the player unlocked. Another point to add , a blueray player has two lasers one to play bluray and another to play DVD's. Lasers can fail so you could be able to play DVD's but not Bluray or vice versa depending on which laser has failed.

Yes you can change the region code on your Ps3.
1.) Go to BD / DVD Parental Control Region Code (don't ask me why its under parental control)
2.) Change the region code from United States to "Other". If it asks for specific check online to see what region the DVD's are from.

These units are generally hardware modified to make them multizone. It may be that the newer discs use a slightly different zone coding and the modified hardware cannot handle this.

Hello, Please get the code here : www.dvdoverseas.com/dvd.htm
www.regionfreedvd.net/

Regards, Jay__Iuh78

i ordered a dvd of boxing, but it wont play on my dvd, it says blue ray what is that?