Question about ASUS A8N-SLI Deluxe Motherboard

1 Answer

System wouldn't Boot

When I turn on my computer, it seems to be booting but yet all that happens is the monitor light just flashes green, and the monitor remains black. I checked the memory, power supply, video card, and monitor and they all work, should i assume that the motherboard or processor is dead? I bought another board, processor and memory, and would you believe the same thing happens too. What could be the problem?

Posted by on

  • menmaatra Jan 02, 2008

    My system powers up but doesn't beep. All the fans are running, the green light is on but it never gets to the start-up screen.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,351 Answers

If your CPU or memory were an issue your Asus board would sound off with BIOS beeps. Asus uses the Award BIOS & you can see what these beeps mean at the link below. Regaurding your PC not able to boot is an issue with your PCIE/PEG video card-in relationship with BIOS setting & the SLI switch card mode that came with your board. When running 1PEG video card you must set this in the BIOS to Auto & you need your SLI switch card connected in its slot. By default, the EZ Selector card is set for a single graphic card. When you install dual PCIE graphic cards on A8N-SLI series motherboards, please make sure EZ Selector card set to the Dual Video Card side and properly inserted. Link to Award Bios beep codes: http://www.bioscentral.com/beepcodes/awardbeep.htm
Will come in handy.
Reading the FAQ's at Asus site will help you better understand your A8N-SLI Deluxe. You'll need to fill in the, "Please Select the Product" first: http://support.asus.com/faq/faq.aspx?SLanguage=en-us

Posted on Jan 03, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The last led light blinks green and sometimes it turns solid red


red light is stands for hardware boot and the green one is stands for system boot and disc boot. when red light remains solid it means your system is in 0% cpu usage and nothing doing, stop working

May 09, 2010 | Intel SC5299BRP

1 Answer

Lg flatron blank screen


t certainly seems like the monitor is not getting a signal. Did this happen after you changed something, or just on normal boot up?
It could be the video card that has failed.
Also, check the pins on the connector; sometimes they can get pushed in.
If you can, try swapping out the video card or use the monitor on another computer.
Good luck,

May 09, 2009 | LG Flatron L1951S 19" LCD Flat Panel...

2 Answers

Won't turn on - green light flashing


When this set is first plugged in the LED will flash for 70 to 90 seconds and then stop. During this time the unit will not operate. This is the amount of time it takes for the Digital Module to boot up. If the blinking LED never stops the Digital module is not booting up and must be repaired. I have done quite a few of these repairs and the average repair cost has been between $250 and $300.

May 09, 2009 | Mitsubishi WS-65611 65" Rear Projection...

1 Answer

LiquidVideo monitor will not come on at bootup.


Blown capacitors internal to the monitor they can be replaced by soldering.
let me know what you want to do

Mar 22, 2009 | Computers & Internet

1 Answer

Power light Flashes on and off stays blue


Hi...there,
It's seems you got a busted AD Board... your LCD bios had been damaged or erased.

Dec 01, 2008 | Computers & Internet

1 Answer

Monitor flashes on and off!


Sounds like you have a bad connection from your monitor to your computer. First check and make sure the connection between them is tight. Does your computer boot up and run though? If your computer is not booting up the monitor will default back to the flashing green power light

Nov 29, 2007 | Dell E173FP 17" LCD Monitor

1 Answer

Monitor goes standby after boot


Look the problem it may not your monitor it's your windows XP. Let me guess you have a VGA/Svideo card. From prior experience I can tell you that dual output Nvidia cards will default to Svideo first, and then "adjust" your windows settings to do so every time even if a VGA monitor is re-connected (HIGHLY ANNOYING). So if the last thing you see before nothing is the Windows XP boot screen, here's how to fix it. Boot to safe mode uninstall your video driver, reboot then reinstall. You can substitute a system restore for uninstalling your drivers if you can remember when the monitor was last working. This really really pissed me off when it happened to me.

Jul 09, 2007 | HP mx705 17" CRT Monitor

Not finding what you are looking for?
ASUS A8N-SLI Deluxe Motherboard Logo

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top ASUS Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18425 Answers

Alun Cox

Level 3 Expert

2678 Answers

David
David

Level 3 Expert

781 Answers

Are you an ASUS Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...