Question about Samson Servo 170 Amplifier

1 Answer

Samson Servo 170 Amplifier

Occasionally, when I switch my Samson amp on I only get sound out of one channel and have to boost the volume in order to get the channel to come on. Occasionally the same channel cuts out for no apparent reason after working fine for a few hours. Anyone know what could be causing this?

Thanks in advance

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers
Re: Samson Servo 170 Amplifier

Check see if youy have some coving the vent or the speak connect right

Posted on Dec 22, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Protect light on amplifier

Oh dear! Protection system has detected a short in the main power amp. The water has caused a great deal of damage. You will have to replace all the parts that have been damaged. Your nose will lead you to where to look.

Jun 27, 2012 | Samson Servo 170 Amplifier

1 Answer

Blown Samson servo 170

The amplifier have problem with the out put drive section. Repairing of such an amplifier should be done by a skilled person. there should be need of repacing so many components if the out put driver transistor is short. If you make any mistake the components you change will also go in to fire.


Mar 31, 2012 | Samson Servo 170 Amplifier

1 Answer

When i turn my servo 170 on the protection light cums on so does the left channel clip light

Disconnect your speakers and see if the same thing happens. If it does not, then you have a problem with your speakers - possibly too many wired in parallel. If the amp. still shuts down, then it'll have to go in for repair.

Jul 23, 2009 | Samson Servo 170 Amplifier

1 Answer

Can I use my amp with PA speakers?

Yes, but stay within the "ohms" limit of the amp.(probably 4 ohm or greater)

Jun 09, 2009 | Samson Servo 170 Amplifier

1 Answer

Hi when i turn on my servo 170 my protection lite stays on

One of the channels in the amp is bad. That channel will need tobe replaced. You may need to take it to a repair shop.

Nov 12, 2008 | Samson Servo 170 Amplifier

1 Answer

Samson Servo 170 - 1 dodgy channel

Dec 02, 2007 | Samson Servo 170 Amplifier

Not finding what you are looking for?
Samson Servo 170 Amplifier Logo

Related Topics:

455 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samson Amplifiers & Preamps Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers


Level 3 Expert

4518 Answers

Are you a Samson Amplifier and Preamp Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides