Question about Heating & Cooling

1 Answer

We have a workman ac unity

The air unit is set but does not turn off...it stays on for along time.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 40 Answers

Thermostat may be bad.

Posted on Dec 05, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Unit not working correctly. The unit worked for the winter, few days ago I turn on the AC and noticed that it wasn't cooling like it should.


It's could be the board or a heat relay. See if you have 24 volts on "x2" im assuming, emergency heat when in cool mode if so it's the board. Or unhook black or x2 or your emergency heat from board and run unit in cool. If heat stays on its a relay

If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Jun 02, 2016 | Heating & Cooling

1 Answer

Is this a thermostat problem or system failure?


it sounds like no communication from stat to board. cable connections

Jun 03, 2014 | Dometic Rooftop RV Air Conditioner

2 Answers

Ask com lg ac window unit control panel stopped working


Hi Gina, Try turning off the unit at the electrical panel. turn off switch, wait 15 min. turn switch back to on position. Turn on AC unit. Hope this helps.

Oct 21, 2013 | Heating & Cooling

1 Answer

AC Blows hot air though i replaced the compressor with a new one


For every AC unit there should be a thermostat which is responsible for detecting heat temperature. The thermostat might be faulty or there might be a gas leak somewhere along the line. It's a common problem in AC units...

Aug 07, 2012 | 2006 GMC Yukon SLE

1 Answer

We have a MS42WN Mr Slim air conditioner. Can you tell me if there is a mode that turns the fan off when the room temperature is reached by the air conditioner? Right now if the AC temp is set for 78 for...


Most units the fan will stay on all the time,if you hit the fan button it will cycle through the speeds. The only way to turn it off is to power off the unit.

Jun 29, 2010 | Heating & Cooling

2 Answers

Carrier 38CKC042300. oUTSIDE UNIT FAN WAS TURNING REAL SLOW. ac UNIT IS OFF BUT FAN TO OUTSIDE UNIT IS STILL TURNING. sHOULD NOT BE TURNING AT ALL WITH AC UNIT OFF


The outside fan may run if the unit is in defrost mode this is normal for most heat pumps it is there way of trying to keep the outside unit from staying iced over so the next time the unit runs it will have air flow through the coil and the ice will not be there to prevent air flow.

Jan 12, 2010 | Carrier 38CKC042 Air Conditioner

1 Answer

Kenmore AC compressor on and off while outside unit fan running


If the out door fan keeps running and the compressor cycles off that would be the overload in the compressor.
What keeps the windings cool is the refrigerant back to the compressor.
For the overload to cycle it would have to be either not enough cooling back to the compressor or high amp draw, which could be the metering device (txv or orifice) or low on charge, or other things would be a bad capacitor, sometimes a bad start relay not staying open, when compressor gets up to speed or anything causing the compressor to draw high amps.
To check the refrigerant, he needs to check the superheat at the compressor it should be appoximately 12° to15°, and next time the compressor goes off if you shut the power off and feel the top of the compressor and if it's hot 130° or higher it's probably refrigerant.

Aug 14, 2009 | Heating & Cooling

1 Answer

Compressor will not stay on


do you know if the fans are running constantly? and if so when the compressor comes on it trips out and the fan remains constant? i would like to know the running amps are they correct.

Jun 08, 2009 | Heating & Cooling

2 Answers

My appartment does not have cenral AC/heat, it has a GE cooling/heater unit in each room. You can set up low heat or high heat but it continues runing on until you manually stop it when is to hot. Is there...


the unit runs all the time because of the fan (ventilation motor)-but it is not working on cooling or heating all the time - The ventilation motor pushes the air from the room through the machine and when the termostat is reading that you set it up for cooler air or warm air it will turn on the air conditioning part or the heating part of the machine-it is very good system actually

Oct 04, 2008 | Heating & Cooling

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

Paul Carew

Level 3 Expert

3351 Answers

Mack Baxter

Level 3 Expert

383 Answers

Marvin
Marvin

Level 3 Expert

83081 Answers

Are you a Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...