Stereo system in 1994 ford explorer

About 3,970 results (0.89 seconds) Search Results

Ford Bluetooth® Wiring Harness - Crutchfield

www.crutchfield.com/.../Ford-Bluetooth-Wiring-...

Crutchfield Corporation
Rating: 4.5 - ‎16 reviews - ‎$19.99 - ‎In stock
Reinstall the factory radio and mount the Bluetooth kit, and you're ready to go. ... 16Reviews ... harness so that I could hook up an aftermarket amp to my factory radio.... works like it's suppose to. says it doesn't work on an 09 Escape but had no .... I purchased this harness to install a parrot ck3100 in my 07 Ford Edge.Missing: pwm

70-5521 wiring harness for ford with 6 CD premium sub amp ...

? 4:30
https://www.youtube.com/watch?v=0jqNafnki0o
Aug 9, 2013 - Uploaded by codieraji
Metra 70-5521 Radio Wiring Harness for Ford 03-Up Amp FordPremium stereo radio 6 CD changer with sub amp inputs. ...16:47. How to wire an aftermarket radio / I Demo install with metra harness and antenna ... How to hook up stock amp/sub to aftermarket head unit "ford sport trac" - Duration: 3:01. Pat.Missing: parakeet ‎pwm ‎98

Car Stereo Wire Harnesses - Radio Wires for all Car Audio ...

www.installer.com/main.php?page=harness
Car Stereo Wire Harnesses - Car Stereo Installation Wiring - Stereo Harness ... If you

if you are are talking about an amp and subs simply get an amp istalation kit take the big red wire and hook it to your battery with the fuse that should be in the kit,thats going to go into the b+ on the amp take the black wire and find somewere near your amp with a bolt going into the car seat bolts work the best, this is for your ground. the little blue wire goes from the back of the radio at the remote wire to the rem inlet on your amp.i always put mine on a toggle switch so if you dont want it on you can just flip it off.To do this just simply run a 12 power wire into the switch and your remote wire coming out of the switch.Finally hook your spearkers into the amp red is posotive black is negative.thats all there is to an audio system.

Bad ground, possibility of some wires touching

remote turn on wire( blue/white) from stereo to amp. RCAs from stereo ( sub out) to amp. Power wire (fused) from battery to amp. Ground wire from clean, paint free chassis to amp. Speaker wire from amp to speaker. ( simplied version). Do you have an amp kit? All the wires, connectors and the fuse will be included in the amp kit.They are rated for the amps power output; 0,4,8 gauge.

As I said in the previous post no the wiring kit is just fie. Yo uwill need to change the inline fuse and that is about it. The problem exists in how you have your subwoofers wired and what impedance is being presented to the amp. Please read my previous response to your your post.

check you Fade and Balance,sometime the ground is used for two speakers sometimes a ground is used more then once will cause your problem ........Good luck......

Probably need an installer - depends on yr/make/model of car - stereo and wiring diagram for sub system. There are lots of questions need answering and if not installed properly, you can certainly damage the stereo, sub system. Subs use a lot of power and improper wiring could cause problems, even fires !

Please rate this info.
1994 Ford Explorer Car Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Light Green/Yellow
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Red or Black
Car Radio Illumination Wire: Orange/Black
Car Stereo Dimmer Wire: Light Blue/Red
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: Blue
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Pink/Light Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Pink/Light Green
Left Rear Speaker Negative Wire (-): Tan/Yellow
Right Rear Speaker Positive Wire (+): Orange/Red
Right Rear Speaker Negative Wire (-): Black/White

You probably need your remote wire re-hooked and make sure the ground wire is good and the remote wire is connected to the right wire(the red wire).

There are a couple of tests you can perform. I'd first recommend checking the shield ground. You'll need an ohm meter. The details can be found on the following page.

RCA shield ground test

You can also test the output with the multimeter. Set the multimeter to AC volts. If it's not an auto-ranging meter, set it to a voltage range of ~2v AC. Disconnect the RCA cables from the head unit. Touch one meter probe to the outer ring of the head unit's RCA jack. Touch the other probe to the metal contact in the center of the RCA jack. With the head unit near full volume and a clean signal source, you should read at least one volt on musical peaks. If you have a bass disc or a test tone disc (~60hz sine wave), use those.