Question about Altec Lansing MX5021 Computer Speakers

2 Answers

MX5021- Remote pod station w/volume, bass and treble control

I lost the "Remote pod station w/volume, bass and treble control", can this part of my Altec Lansing MX5021 be bought?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: MX5021- Remote pod station w/volume, bass and treble...

Now this speaker is available with you
if yes mail me

Posted on May 21, 2013

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 38 Answers
Re: MX5021- Remote pod station w/volume, bass and treble control - Altec Lansing MX5021 Computer Speakers Computer Speakers


Posted on Dec 04, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Altec lansing mx5021 wired controller not working

Sounds like you might have a wire loose at the other side of the controller. This is a easy thing to find out. Just unscrew the side screws that hold the back board to the cabinet. Don't unscrew the screws connected to the speaker wire clips unless the back doesn't come off. Just look for a disconnected wire at the controller jack then put it back. If there is no loose wire then you might have a bent female contact at the outside of the controller jack. You would have to look for this looking into the holes where you plug the cable into the controller jack. If you see a bent contact then use a thin nail of ice pick and insert it into the hole where the bent connector is to try to re open the contact so the cable can slip into it easy. Don't forget to unplug the power first.

Nov 07, 2013 | Altec Lansing MX5021 Computer Speakers

1 Answer

Where can I find a satellite speaker that controls the sound?

For the most part volume is controlled on computer, though speakers may have separate volume \ bass \ treble controls. Or, are you looking to purchase?

Aug 31, 2012 | Harman Kardon SoundSticks II Computer...

1 Answer

Alright so somehow I lost my Z-2300 2.1 sound system's wired remote where it controls the volume and bass and I was wondering where I could go to buy a replacement?

People should read the question before answering!! He has LOST the remote so how can he switch on the power switch on the remote.........

Jan 07, 2011 | Logitech Z-2300 2.1 Computer Speaker...

1 Answer

Hey there, I have JLB Creature II speakers, that have been working fine for nearly a year. Until one day, when the treble's maximum volume became a lot lower than before. The bass still rocks it up like...

Hi Nikita,

The problem may be with the internal electronics of these speakers, especially the sub-system that controls the treble. If they are still under warranty, you should talk to the dealer. If not, you should contact a technician.

Hope that helps,

Mar 22, 2010 | JBL CREATURE II Computer Speakers

1 Answer

Can't adjust bass and treble

The only adjustments available on the unit are Volume and Bass (Subwoofer Level). There are no Mid-Bass or Treble adjustments.

Sep 20, 2009 | Jasco GE 98903 2.1 Speakers

1 Answer

Altec lansing FX5051

I have Altec Lancing Fx5051 5.1 No doubt the Sound Quality is Awesome however, I had some Issues with the Speakers and the Power.. While Playing the Device .. Suddenly the Sounds become so Low that it becomes Difficult for any one to Listen.. but again after some Adjustment is Volume.. the Sounds Come back ... and this Things had to be Repetead every 2-3 minutes .....

I had Called up the Service Center Guys .. they asked me to Change the Power Supply to another point and Try ... I did but nothing worked ...

Now that I have Changed my entire Home with New Electrical Wires and Earthing Properly Fixed ... the Problem Still Persists ... But Now I see that the main Woofer is Not taking Power ... I dont Know wot is wrong ... Can you Please help me ... ...

Nov 08, 2008 | Altec Lansing MX5021 Computer Speakers

1 Answer


the controller chip inside your altec is possibly defective. i have the acs 45.1 and the unit wont turn on.. the culprit is the main power/volume chip.

Apr 30, 2008 | Computer Speakers

1 Answer

Altec Lansing 4.1 ADA880

if you are a technically skilled person
simply clean all the IC(chip) leads, by using a blower or using a painting small brush
the dust come in contact with the other pins that make this problem

Jan 23, 2008 | Altec Lansing ADA 885 Computer Speakers

Not finding what you are looking for?
Altec Lansing MX5021 Computer Speakers Logo

Related Topics:

1,562 people viewed this question

Ask a Question

Usually answered in minutes!

Top Altec Lansing Computer Speakers Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Carlos L. Burgos
Carlos L. Burgos

Level 2 Expert

508 Answers

The Knight
The Knight

Level 3 Expert

66456 Answers

Are you an Altec Lansing Computer Speaker Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides