How to program TV Philips model 275t6210/27 with

How To Program A Philips Universal Remote ' Codes For ...

codesforuniversalremotes.com/program-philips-universal-remote/

Here is how to Program any Philips Universal Remote Control. Turn on the device you ... Remote Control Codes December 21, 2015 at 1:19 pm. Stephanie,

Codes For Universal Remotes ' Universal Remote Control ...

codesforuniversalremotes.com/

Universal Remote Control Codes For TV & Audio. ... Codes for Philips Universal Remotes · Sanyo TV Codes for Universal Remotes · Codes for .... I have an 19 inch Emerson flat screen and a RCA universal remote. Please help with the code ..

These are the setup codes for Samaung TV;

004/ 005/ 009/ 015/ 104/ 105/ 106/ 109/ 133/ 172

http://157.254.235.130/public/IBR53FMcodesREVb.pdf

this should help

Hi, I have a few things for you to try.
1. Your TV "6424TF" seems to have problems with its IR "Infra-red" sensor going bad. This is a common problem with your model TV. If this is the case no remotes will work on your TV.
2. Because I do not know the model of your universal RCA remote I cannot tell you how to program it.. please supply the model number of it. Try looking under the battery cover. might be an "RCR..." number. I need to know this because all universal remotes have different codes and programming methods.
3. To know 100% if its your TV that's bad you will need the original remote for your TV. I have already looked up your original remote and you can purchase a brand new replacement that will work right out of the package (assuming your TV IR sensor isn't broke) here: RR0108UD for all sylvania TVs . no programming is necessary for this remote.

I know this is an old post, however if anyone else needs to know how to program the RCA RCR 615 DCM1 universal remote here is how: Turn on the device you wish to program, dold the device button you wish to program (tv, vcr, dvd, etc.) While holding the button with one hand, press and hold the power button with the other, hold both buttons until the device button lights up and stays on then release both buttons at once. Light should remain on. Point remote toward the device and press play button every 5 seconds until device shuts off. Once the device shuts off, with remote still pointed toward the device, slowly hit the reverse button (rewind button) until the device turns on again and then hit stop button. Now your device should be programmed. Repeat for each device. Hope this helps someone, because I had this problem myself and I played around with the remote until I figured it out . This may work for other RCA RCR----- remotes as well.

You went on the web to post your question, why not use the web to go to the manufacturers web site for your remote that your trying to program and get the codes for it.

i need codes for ca sanyo tv

goldstar television code: 004
press code search on remote
press tv on remote
enter code 004
press power on remote

www.rca.com/customerservice... click the find codes link.. then select your clicker's model number from the drop down box.

The problem is that it does not list the steps to program the remote after you have the correct code. Does anybody have this information?