Messed up controler port

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

If your talking about the USB connector (Inside) it should be straight.
The male and female will look like they on on opposite sides.
Like the image below:

The repair to the winder may be only £30.00 but will the watch then work well.Parts for old Omegas can cost a premium and the watch may need a service.A service to an Omega by a good watchmaker will cost £170.00 ish and if it needs parts this will rise.
As to value if its 14ct on a bracelet the gold is worth about £12.00 a grm so if its 30g then the gold is £350/£400.00
Its hard to say what to pay without knowing if the watch works well,if it needs £200.00 spending on it the value is reduced to little more than the gold value so id weigh the watch work out a gold value and then a small amount.
If you need a repair try www.rolexrepairs.co.uk they offer a free estimate.
Regards

inside your freezer behind the vent if you stick your hand on the inside you should feel air blowing if not then the fan is gone if the fan is slowly making revolutions then you should replace also you can find the part at marcoe appliance parts or allbrands appliance parts they willmail directly to your door hope this helps plz write back if it is not your fan inside the freezer

This "chip" belongs to a keyless entry remote. If you open up a remote for a saturn, you'll find this inside.

if you bent the card, you broke components inside...your going to have to get a new card.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

There is a black and a white wire that runs up through the middle of that mess you are looking at. They run down through the center and to the light. First get a can of spray silicone I use a brand from Gunk.Put the spray nozzle in the pull chain switch and give it a little spray. try the pull switch and see if that works before any thing else. You will not get zapted.

Then you learn, when everything works fine, dont mess with it! Have a look at the gold pins that rely the body to the lens. Also check that your lens manual switch focus is engaged... Try a friend lens to see if its your cam or the lens...

it could be water valve or ice maker that has gone bad.check all connectins to icemaker and tubing to icemaker and water valve.

Simple. Just solved it with advice from this site. If you see any of the gold prongs touching the side (or possibly each other) then find a thing tool and try to hook the gold prongs so they point direct upwards. how bad they get bent doesnt matter, just get them all standing up and not touching the sides. you probably cant use the port again but atleast it turns on.