My lcd display is blurry, i plugged it into a monitor and its still working, the lcd sometimes works fine sometimes not

Doreen, try going into display settings and make changes there, veiw changes if you find better choose ti.

trsgcvhuytr

Sounds like your CRT is dying. Sometimes older ones can take longer to turn on, I would suggest upgrading to an economy LCD, they're pretty cheap.

If you're using a VGA cable (a.k.a the blue plug) you'll have to use the Auto-Adjust feature on your monitor.

well try to plug any other monitor . if other monitor works fine then it's ur lcd monitor display prob. or ur motherboard display driver problem

If you've connected an external monitor to your computer and the image is coming up fine then that means your video card on the motherboard is good.

The only other parts it could be is the LCD Flex cable that connects to the LCD screen to the motherboard, the LCD Inverter that powers the LCD screen or the LCD screen itself. Usually you can find a used screen that is complete with all those components on ebay.

Does the monitor plug into a card or the motherboard socket?

The VGA connection should be fine; I have DVI and when I switched from analog, the difference was pretty minimal, to my eyes.

Is it just the fonts that are blurry, or everything? If fonts only, then this almost certainly suggests that running the ClearType tuner again would solve the problem. But this applies to all displays, so if one is good and the other is not, then this isn't it.

If everything is a little blurry, then this suggests one of two problems -- the first, you report trying, which is that the display adapter is set to a different resolution than the native resolution of the LCD monitor itself. Your display adapter should probably be able to drive 2 monitors (the built-in laptop monitor and the external monitor) at once. You should be able to set their resolutions separately.

Assuming Windows XP: Start > Control Panel > Display > Settings > at which point, you should see two monitors listed in a dropdown. Set them to their native resolutions there (using the slider bar, usually all the way to the right), and save.

If you do have the display resolutions set to their native resolutions for both monitors, then it's possible that your external monitor is messed up. A quick test would be to run the on-screen settings, usually from a button on the monitor itself. If what is displayed there is sharp and what is displayed from Windows is not, then this points to a problem with the display driver. If everything, even the on-screen display is blurry, then perhaps the monitor settings are messed up -- usually there's an option to restore to factory settings -- try that.

If that doesn't work, I'm probably out of ideas, unless you have further information.

Sometimes humidity is the problem . Please keep the camera under room temprature and on position for maximum time . For the Battery low problem first try using alkaline or lithium ion batteries and see if they work fine...

Frontech external Miracle TV tuner not working with LCD(ACER 15") monitor. Error msg "input format not suppoting". But CRT monitor (samsung 14") is working with the same.
Pl give advice [email protected]