Question about Dell Inspiron 1200 14.1 XGA LCD Display-320-4222 (3204222) CD-ROM Drive

1 Answer

Sound problem Hello recently my computer had been infected with viruses and I had to get it all reformatted.My computer is now running awesome but I need help restoring the sound. Please advise me.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 98 Answers
Re: Sound problem

You need to install mother board drver.. it contains audio/video/etc/etc driver.. if you dont have search the internetor web site of manufacturer..

Posted on Feb 08, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

My computers audio card has been deleted

do you mean the audio drivers have been delated? was it done by your anti-virus which is the case most often when a pc virus infect programmes.
try downloading and reinstalling the drivers again. go to the site link below by clicking on it and do choose the exact one. it will be very helpful to enter the PN/SN (pin or serial number of the device-should find it under the pc) should you have a problem choosing. Good luck

Jul 04, 2010 | Compaq Presario 700 Series: 1170B01...

1 Answer

How do i get rid of the KERNEL_STACK_INPAGE_ERROR on my d600? Occasionally it says UNMOUNTABLE_BOOT_VOLUME instead. Help?

This issue can occur if a requested page of kernel data could not be read from the paging file into memory, or the master boot record is infected with a virus. To further determine the possible cause, you must properly interpret the error message. If both the first and third parameters are zero, then the four parameters are defined as:
  1. 0 (zero)
  2. Page Table Entry (PTE) value at time of error
  3. 0 (zero)
  4. Address of signature on kernel stack
If either the first or the third parameter is not a zero, then the following definitions apply:
  1. Status code
  2. I/O status code
  3. Page file number
  4. Offset into page file
If this is the case, the cause of this issue may be determined from the second parameter (the I/O status code) by using the following information that is listed in a "value of second parameter" followed by "general cause" format:

0xC000000E, or STATUS_NO_SUCH_DEVICE: the drive went unavailable, possibly a bad hard drive, disk array, and/or controller card.

0xC000009A, or STATUS_INSUFFICIENT_RESOURCES: lack of nonpaged pool resources.

0xC000009C, or STATUS_DEVICE_DATA_ERROR: bad blocks on the hard disk.

0xC000009D, or STATUS_DEVICE_NOT_CONNECTED: bad cabling, non-termination, or the controller is not able to obtain access to the hard disk.

0xC000016A, or STATUS_DISK_OPERATION_FAILED: bad blocks on the hard disk.

0xC0000185, or STATUS_IO_DEVICE_ERROR: improper termination or defective cabling of SCSI-based devices, or two devices attempting to use the same IRQ.

To resolve this issue, use the appropriate method:
Boot sector virus loadTOCNode(2, 'resolution'); To determine if you have a boot sector virus, run a current virus-checking program, and if needed, disinfect your computer.
Not a boot sector virus loadTOCNode(2, 'resolution'); View the System Log in Event Viewer for additional error messages that help you determine the device that is causing the error.

Bad block. Stop 0x77 is caused by a bad block in a paging file, or a disk controller error, or in extremely rare cases it is caused when non-paged pool resources are unavailable.

If the first and second parameters are 0, then the stack signature was not found in the kernel stack. The cause of this issue is defective hardware. If the I/O status is C0000185 and the paging file is on a SCSI-based hard disk, you should verify the disk cabling and SCSI termination.

If the I/O status code is 0xC000009C or 0xC000016A, this normally indicates that the data could not be read from the disk due to a bad block.

If you can restart your computer after the error message, Autochk runs automatically and tries to map out the bad sector. If for some reason Autochk does not scan the hard disk for errors, manually start the disk scanner. If your computer is formatted with the NTFS file system, run Chkdsk /f /r on the system partition. You must restart your computer before the disk scan begins. If you cannot start your computer due to this issue, use the Command Console and run Chkdsk /r.

Defective or unreliable random access memory (RAM) is another common cause of this issue.

Verify that all the adapter cards in your computer are properly seated.

Ensure that all adapter card contacts are clean.

Disable system caching in the BIOS to see if this resolves the error.

If this does not resolve the issue, your computer mainboard may be damaged.

Oct 23, 2009 | Dell Inspiron 1150 Latitude D600 14.1 LCD...

1 Answer

HL-DT-ST DVDRAM GSA-T20L ATA Device cannot read DVD

first of all check that ur laptop is not infected by viruses,because sometimes it happens due to virus...
make sure that the DVD you r trying to run is scratch free....ans is clean...

Sep 12, 2009 | CD Drives

1 Answer

Driver door keeps opening and closing

Could be virus infection install update to your antivirus or better check free antivirus.

Leave a comment, tnx

Apr 08, 2009 | E-Machines emachines (emachinees) CD-ROM...

2 Answers

I am the administrator!why is access denied

Try right mouse clicking on the software you are trying to use & select run as administrator. This works for me. Hope this helps.

Mar 11, 2009 | E-Machines emachines (emachinees) CD-ROM...

1 Answer

Nu cdrw/dvd dbw-521 draw opens and closes repeatedly


This sounds mostly like you got a Virus in your system, please make sure you got a good one like or Antispyware....

If you are familiar with windows services and startup Items you can find the one that is infected.

Let me know...

Dec 12, 2008 | CD Drives

1 Answer

Dvd-rw drive (d:)

your laptop is infected by any virus so format your laptop and install a fresh copy of os .or try it with different cd because some cd,s are DRM protected,and not run in the laptop but run in cd player

Dec 21, 2007 | CD Drives

1 Answer


You may have a trojan horse which is similar to a virus. They usually come from MySpace or such. Related to the mythical trojan Hoarse, they disguise as something good and once on your computer will infect vital areas of the system. You may just need to uninstall and reinstall the driver for the CD/DVD (whatever) drive. Hope this works.

Nov 25, 2007 | CD Drives

1 Answer

Computer keeps shutting off

First thing that comes to mind is that it is overheating which causes the shutdown problem. When running the ant-virus the computer uses a lot of resources and it gets hot fast. When laptop is turned off, inspect all areas for dust build up around any openings. You can also remove the compartment lids and inspect those too. The best way to clean out dust is to use compressed air that comes in a can and q-tips. Blow the air into all the openings and use the q-tips to whip away dust build up. Once you think that it is clean, turn it on and make sure that the fans are running if your unit has them. While it is running, you can use a free on line scanner that uses less resources just in case it still overheats over time.
With sufficient cooling, your laptop should perform much better too.

Nov 23, 2007 | Compaq Presario 900 /1500 Series EVO...

Not finding what you are looking for?
CD Drives Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dell CD Drives Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

NewYork kyocera HP...

Level 3 Expert

513 Answers

Are you a Dell CD Drive Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides