I have a compaq Armada v300 and the problem is I put in a new hard drive. but when I went to boot the laptop I got an error msg. "1782-disk controller failure. then it left from the screen to another with the error " non-system disk or disk error replace and strike any key when ready. when I do I keep getting the same error msg. I have looked and there is no floppy or cd in the laptop and I continue to get the same msg. I have even changed the boot seq. and still get the same two error messages. What can I do to stop the error msg. so that I can boot the laptop. I want to reimage it.
Try removing the jumper from the harddrive, then restart
or
Take the jumper off restart shut down and then put it back on again
or
remove the CMOS battery from system board and boot once after booting shutdown your system and insert the battery back, again start your system and press F1 next time it won't ask you for pressing F1. reset your BIOS after that (time,date,etc.)
My unit is a Dell Latitude D600 series. Error which appeared in big blue screen is: Stop: C0000139 (Entry Point not found) The procedure entry point GdiGetBitmapBitsSize could not be located in the dynamic link library GDI32.dll
cannot open CD room and cannot start computor to get into operationg system can get into BIOS area...
(More)
cannot open CD room and cannot start computor to get into operationg system can get into BIOS area but
lenovo t61 laptop has no tcpip communication ran the "system health" test in Lenovo PC...
(More)
lenovo t61 laptop has no tcpip communication ran the "system health" test in Lenovo PC doctor 5 for windows. os XP pro service pack 2 ethernet card has both lights operating showing conection to network and linkbeat Lenovo PC doctor 5 said network card failed test.