A pin has broke off where the cartridges slide a long how much to repair it and where

If the cartridges can be removed, pull them out and try spraying an electronic contact cleaner, power off, and make sure it is safe for plastics, onto the cartridge pins. Then, Gently, slide the cartridge in and out of the socket several times to clean both the socket and cartridge. May have to do this a couple of times.

The steering column wheel has 2 pins pushed into the back side of it and as you turn the steering wheel making a turn, the pins slide over the humps of the blinker signal. As you return the wheel back to center to drive straight, these pins then hit the humps in the turn signal and push the turn signal back to the original position. It sounds like one of these pins fell out or broke off. You need to pull steering wheel and check to see if these pins are still inserted on the back side of the steering wheel.

firing pin broke or not striking cartridge hard enough

If your printer is Canon try this:
1. Turn off the printer
2. Release all cartridge, black and color. Press cartridge locker left of home cartridge and Slide home cartridge to left, to parking position. And release the cartridges.
3. Leave the up cover open and turn ON the printer.
4. Clean cartridge pin from ink with wet tissue until clean
5. Plug in the black and color cartridges and close cover
6. printer should working normally, indicated by appear I in display, not E30.


If it is not please tell us the model

bezel gshock dw8800

yes you can repair it from vendor.

There are two ways. You can replace the rubber cartridge by simply removing any retaining clips from the end of the blade and sliding the old cartridge out, then sliding the new cartridge in and reclipping. Replacing the entire blade isn't that difficult either. Tilt the wiper back from the window so you can see where the blade pivots on a pin with clips holding the pin. Gently pry the wiper out from the clips on either side of the pin(you only need to pry on one) while pushing the blade in toward the wiper cover. It should pop out of the clips with a small amount of effort. You'll then have to weasel it out but it comes out pretty easily. Take off any adaptor that comes attached to the new 14" wiper and install.

you wouold have to take the insider door panels off and you can either use the new pins or locate the old ones inside the doors.if i were you i would put some type of adhesive on them when i put them back in place so it wont happen again

Hi, click printer icon ,select printer setting .,cleck maintenance ,navigate below select replace ink cartridge , printer set in middle , unplug power cord to access repair or reload ,