Zebra printer P430i. wait for temperature check

Here's the Service Manual ftp://ftp.abico.com/Zebra%20Printer/P430i/P430i_Service_Manual.pdf Section 1.2.1 Pages 4 and 5 show numerous meaning for a blinking LCD Panel

my printer is giving An error in v1.2 lcd init Zebra P430i solution what should I do to solve panel.

im having the same problem. does anyone have a solution???

turn printer off, press PAUSE button, turn printer on and wait 5 seconds then release the button. The printer is going to print the test label, check if coming some withe lines across the print. try to clean the printhead and the rollar, if pressist, need to replace printhead.
Please check if the cable from the printhead is totaly plug-in

The P430 and the P330 are similar, P430 print both sides from the card, and the P330 just print one site, but the commands to send are the sane. Please try !SA command from the driver.

Try cleaning kit first. If problem is same you need to calibrate sensor voltage. That can be adjusted by trained zebra technition.

plese send the command !SA from the driver.

ribbon cut again and again after put 2 or 3 cards pls give instruction how to solve the problem.

Continue printing while the print head reaches the correct operating temperature.

Have you cleaned the printhead yet? If it is easy to get to. Use some alcohol and cotton cloth.

I’m happy to help further over the phone at https://www.6ya.com/expert/jayw_0e86fb055a7b73de