Question about HP LaserJet 3015 All-In-One Printer

1 Answer

No print outcomes from hp laser jet printer.

No print out comes from hp laser jet printer (model p1505n) .plain white sheet comes out, when i gave print from system. if anyone know what is the problem and how to rectified, Please send to my e-mail id i will give my mail id below.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Restore Your Printer To Factory Default Setting.
To restore the factory-set defaults
1. Press MENU/ENTER.
2. Use the < or the > button to select Service, and then press MENU/ENTER.
3. Use the < or the > button to select Restore defaults, press MENU/ENTER, and then press
MENU/ENTER again to confirm your selection.
The device automatically restarts.
Configure the printer as below :
Network configuration
You might need to configure certain network parameters on the printer. You can configure these
parameters from the printer control panel, the embedded Web server, or for most networks, from the
HP Web Jetadmin software.
NOTE For more information about using the embedded Web server, see Using the embedded
Web server.
For a complete list of supported networks and for instructions on configuring network parameters from
software, see the HP Jetdirect Embedded Print Server Administrator’s Guide. The guide comes with
printers in which an HP Jetdirect embedded print server is installed.
Manually configuring TCP/IP parameters from the printer control
panel
Use manual configuration to set an IP address, subnet mask, and default gateway.
Setting an IP address
1. Press Menu.
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight I/O, and then press .
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press to highlight TCP/IP, and then press .
6. Press to select CONFIG METHOD.
7. Press to highlight MANUAL, and then press .
8. Press to highlight MANUAL SETTINGS, and then press .
9. Press to highlight IP Address:, and then press .
10. Press the or arrow to increase or decrease the number for the first byte of the IP address.
11. Press to move to the next set of numbers. (Press to move to the previous set of numbers.)
NOTE To cycle through the numbers faster, hold down the arrow button.
12. Repeat steps 10 and 11 until the correct IP address is entered, and then press to save the
setting.
13. Press Menu to return to the Ready state.
Setting the subnet mask
1. Press Menu.
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight I/O, and then press .
ENWW Ne.
If problem persist , reinstall the drivers .

Posted on Aug 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hp color laser jet cp4025 blinking yellow light


Yellow toner is getting low, or check to make sure your print driver is set correctly for this printer.

Mar 22, 2013 | HEWLETT PACKARD - LASER JETS New - Hp...

1 Answer

OUR PRINTER MODEL NO IS HP LASER JET 3055 PROBLEM IS WHEN WE TAKE XEROX COPY OR PRINT COPY ONE SIDE PAPER COMING BLACK SHED TYPE


Firs check toner catridge or else problem with the theflon sheet in the fuser unit need to replace it.

Jun 01, 2011 | HP Office Equipment & Supplies

1 Answer

Printer will not print queque HP Laser Jet P1505


first remove the power and usb pin from the printer wait for few minutes then connect them back into the socket then click printer icon in the task bar and open it and remove all the contents then again remove the power and the usb of the printer and restart your computer then connect the power plug and the usb into the printer then click start settings printer and make your printer default then right click your default printer and select properties in the printer properties click print a test page

Apr 01, 2011 | HP LaserJet P1505n Printer

1 Answer

Hp 1505n laser jet, Makes clicking noises when printing. Slight smear on left side of page.


There are two things that can cause print quality problems and a noises. One being the toner cartridge and the other being the fuser assembly. If you have already replaced the toner cartridge and it did not take care of the problem then the fuser may need to be replaced. You can take it to a local printer repair shop to get it fixed.

Sep 16, 2010 | HP LaserJet P1505n Printer

1 Answer

HP Photosmart C7280 All in One Printer. I am trying to print on new check paper, but it just keeps running it through and then prints on the regular white paper. Any quick fixes?


Check the preferences setting in your Printer Dialogue box (the pop-up that comes up when you attempt to print... the paper settings may be set to standard, which you can modify...

A quick-fix is also to simply print to plain paper, place the newly-printed form in the scanner, and press "copy" on the printer itself (the physical button, not from Windows), with the check paper loaded (place in just one sheet, as not to waste ink)

Hope this helps!

-- RT

Sep 03, 2009 | HP Photosmart C7280 Laser Printer

1 Answer

Error code A7 on brother mfc-420cn


Hi there
(A7 One-line feeding timeout error. )

Brother Error Codes RAM clear (most models)
Quickly press function * 2 8 6 4
Display should read maintenance
Press 0 1 for a full ram clear, or 9 1 to retain user data
Display should read reinit for a few moments then redisplay maintenance
Press 9 9 to exit the maintenance mode

Other maintenance mode switches:
01 ram clear (see 91 below)
02 scanner initialize (feed a white sheet, then a black sheet)
05 white level
09 print test
10 modify soft switches
11 print configuration list
16 panel test
19 CML test
20 signal test
21 tonal test
23 filter RX
54 scan edge
55 scanner area
66 test print memo
75 display drum life (if enabled on laser models)
76 reset drum life counter (laser models)
91 parameter initialize (user programming remains intact)
95 protection
Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks

Apr 05, 2009 | Brother MFC 420CN All-In-One InkJet...

1 Answer

Deleted document is hung up and will not release on HP Laser jet P1505n


You can try turning off the printer and waiting for the print spooler to time out.

Aug 19, 2008 | HP Office Equipment & Supplies

Not finding what you are looking for?
HP LaserJet 3015 All-In-One Printer Logo

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Office Equipment & Supplies Experts

Clive
Clive

Level 3 Expert

4345 Answers

Thomas F. Schneider

Level 3 Expert

2715 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18429 Answers

Are you a HP Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...