I am getting a message "Warning: more solutions may exist" How do I fix that?

This is the simplest & easiest fix, to make your '94 Cont. drivable, without having to listen to incessant CHIMES beeping every five minutes, due to faulty sensors and electrical glitches from the junk message system. Go under the dash, on the right side of the steering column and remove the plug (10 wires) from the 'warning chime module.' There is a tan/yellow wire in that plug on pin #7--that is the "tone generator" wire. CUT IT.!!! Now, when all of those faulty inputs try to get to the warning chime module--they CAN'T! Problem solved--no more beeping. This does not disrupt the chime from sounding if you open the door with your keys in the ignition, or with the lights still on--it continues to protects you from THAT. Remember to watch your OWN coolant & oil levels--to make sure no REAL problems exist--and you're good to go!

normally disconnecting the battery for about ten minutes then reconnecting is enough to reset the computer and get the light to go out. although is there is a existing problem i will come back on after about 10 minutes of driving.

Hi,
This is because your system was infected with a virus (prgds.exe) and the same virus was successfully removed from your system by the antivirus software. Now the path for the same virus file still exists in registry / windows startup list. As the virus file was removed and no more exists, you are getting this message. This is normal. no need to worry.
In Run prompt type the command "msconfig" and under the startup tab, uncheck the item which refers to this .exe file and restart your system. This will fix your problem.

Please rate the solution.
Thanks

try reseting the cartridges timer and check

The ABS light will stay on only when a problem exists. Once repairs have been completed and no problems exist the ABS light will go off on it's own. Take the car back to where you had the work done and have them fix it. It shouldn't cost you anything. If the ABS light was not "on" when you took the car to them, DO NOT let them charge you to fix it. They caused the problem. They can fix it. Good luck. Hope this is helpful.

You have a bad scanner assembly. Very expensive to get fixed

Hi,
This is a common problem. But there is a solution for this problem.
go to Messaging. Then hit Options. Scroll down to settings.
Hit text message. Options - Then "Message Centres".
Hit the Edit button and the following number should come up:

+47973100973
Save it and try sending messages. If again the same problem exist then call up your customer care who provides the services of your phone like Airtel, Reliance etc.. Ask the message center number and follow the above steps and save that service center number. Hopefully it should work. Thank you......

slbcsp.dll - this registry does not exist
sccbase.dll - this registry does not exist
gpkcsp.dll - this registry does not exist
Enum - installer can not access

Please wait for a moment until the warning message disappears and the Access lamp extinguishes. The normal operation will resume soon. The start-up time of the IBM Microdrive, until it becomes readable by DiMAGE 7, takes longer than Compact Flash. In the meantime the camera may not detect card existence.