Question about Whirlpool Freezers
Upright Whirlpool freezer.
CALL A REPAIR SERVICE LOCALLY . NO DOUBT IT NEEDS FREON AND ONLY PRO'S CAN DO IT FOR YOU
Posted on Apr 22, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
This one sounds like the defrost timer is not working and you are not getting a defrost cycle every 6-8 hours (or when needed). Another issue could be that air (moisture) is getting in from a leaky door seal, etc. and causing the freeze up. If you have a sealed system problem where the cooling coils are not uniformly frosted up then the defrost thermostat will not "know" there is an ice condition and therefore not go into defrost mode (same issue if the defrost t-stat is bad). After you have ALL the ice out of the unit it would be a good idea to take the interior rear cover off so you can view the coils. Start the freezer back up and watch over the next 1/2 hour or so to see that the entire coil is frosting up uniformly. If it isn't you may have a plugged system, a leak causing low refrigerant, etc. If over time the coils look uniformly frosted up you may have a defective defrost heating element itself (no heat, no defrost sort of thing). The defrost elements can be checked with a multimeter for continuity if you know how to do that sort of thing. It's hard to know a person's ability by these forums or if they can tackle certain test procedures.
Posted on Nov 13, 2006
It is most likely the relay and overload or the thermostat. What is the complete model # on the sticker inside the freezer?
Posted on Oct 15, 2007
SOURCE: Freezer runs constantly
not necessarily, is it maintaining temp? all food staying frozen? especially ice creams if stored in there. most newer freezers displace the heat generated while cooling the food through copper lines running through sides of unit, helps to cut down on air temp differences between the inside (0 degrees) and outside temp to prevent moisture and possible condensation causing premature rusting of unit
Posted on Mar 03, 2008
This could be a bad controller since you had a power outage, or even a bad motor. Look in your operator's manual and see if there is a reset button somewhere near the motor.
Unless you are well versed in electronics and have the proper equipment, you'll be unable to diagnose the control board anyway.
As a last ditch effort, which sometimes works, unplug it for about 5 minutes and then plug it back in. Make sure your thermostat is turned to the correct setting.
Posted on May 12, 2009
Is your circulating fan working?
Sometimes they stick and need a shot of WD 40 and then work
it back and forth a little until it wants to take off again. Keep me informed
and PLEASE give a Thumbs Up for the effort. The Raz Shack
Posted on Apr 21, 2010
Tips for a great answer:
Aug 12, 2017 | Whirlpool Freezers
Jun 29, 2015 | Whirlpool EV250NXTQ White 24.7 Cu. Ft....
Sep 18, 2014 | Freezers
Aug 28, 2014 | Whirlpool 19.6 cu. ft. Upright Freezer...
Jul 03, 2014 | Whirlpool EV160NZTQ Upright Freezer 16 cu...
Mar 06, 2013 | Whirlpool EV160NZTQ Upright Freezers
Apr 21, 2011 | Whirlpool 15.2 cu. ft. / 430 liter Upright...
Mar 09, 2011 | Whirlpool 16.7 cu. ft. Upright Freezer...
Jan 28, 2010 | Whirlpool 17 cu. ft. / 481 liter Upright...
55 people viewed this question
Usually answered in minutes!