OCE PLOTWAVE 300 WILL NOT COMPLETE STARTUP IT WILL GET ABOUT 3/4 THROUGH AND STALL UNTIL THE SCREEN GOES TO SLEEP MODE. WHAT CAN I DO?

I'm assuming you filled the toner. Hopefully you only put one bottle in and it isn't overfilled, where you could have even more problems. If shutting the machine off and turning it back on again doesn't get the system to start conditioning, there may be a problem with the toner hopper. Please call an Authorized Oce Service Representative.

There is no online or free software to do this. You have to call an authorized service provider for this to reload the OS and firmware.

Fuser Temperature Protection Circuit Failed. Turn off the printer completely. Power off in front, and turn off main power at right, rear, bottom and unplug from the wall. Open up the fuser and take off the right hand cover. This is High Voltage. If you are uncomfortable with risking your health, do not proceed further. You will see 4 connectors (black, usually but with red insulators) that plug into the right hand side of the fuser. Unplug them and check the connectors as well as test if they are seated correctly. Ensure the red insulating jackets are pushed toward the connectors. IF everything looks OK, and the printer still exhibits this error code you will have to call an authorized Oce service technician.

Probably a power supply in the Power M Controller. Call an authorized Canon/Oce technician for parts and service.

Clean the paper tray, rollers, and clear any jams. The OCE Plotwave, being a large scale printer (used for posters and the like) is prone to jams and gumming up of the rollers. The error occurs when the paper doesn't move along properly and the sensors that read the surface and adjust the paper can't get it to adjust. Other issues can cause the same generic error. This includes incorrect PIN settings on the mainboard (some of these printers have PIN controllers that determine if it will read a certain way). It could be a read/write error in the USB control board (check to make sure all ribbons are correctly seated and all connections are making proper contact and are in the right ports). I suggest trying the OCE cleaning tool to see if that helps. Oc PlotWave 300.

Fuser NTC 1 not working properly. Replace.

Transfer stall USB bitmap data. Either the USB board is flaky or the Spider PBA is faulty. Before replacing anything, upgrade the software and firmware to the latest level. The new software may solve the errors.

Error 08130 Fuser temperature protection circuit failed. This could be the Spider PBA or it could be the connections to the fuser itself.
Best to call an authorized service rep.

JAI UN PROBLEME AU PLOTWAVE 300 MARQUE OCE
CODE ERREUR 8510
C QUOI LE PROBLEME ET C DU A QUOI ET QUESQUE JE DOIT CHANGER
MERCI
REPONDEZ PAR EMAIL
[email protected]

I've never seen this error in my life, and it is not in the manual. I recommend you call an authorized Oce technician to come take a look at it. It might be a problem with the controller.