Question about Sub-Zero Refrigerators
Previously it was not my property, so I'm not sure if it cooled or not, was shut down transporting it and the door was a little unlevel, when I start it starts the compressor but does not cool anything, you can help me. Thanks.
How soon did you start it up after you moved it & put it in its place?
If you plugged it in to soon after moving. Oil may have still been up in the wrong place of the compressor. Unplug it for about an hour. Then plug it back in. By plugging it in to early after moving you could have burnt up the compressor. This happens often.
Posted on Feb 09, 2019
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Check if the condensar ( outside fan unit) is getting enough free ventilation. IF there is no free air flow you will mostlikely be triping the unit due to short cycling. Ie the unit is pulling its own discherge air causing the compressor to trip due to high back pressure
Posted on Sep 07, 2007
SOURCE: Sub-Zero 532 not cooling
Simple think I guess - just pull down a little a plastic fan blade on motor shift it will produce a powerful air flow. Fan blade should sit pretty close to the shift end. ;)
Los Angeles Sub-Zero refrigeration experts
Posted on Jul 23, 2008
that's about right, if the compressor is drawing more than 4 amperes, then it is no good.
A reminder also to check the condenser for dirt and debris that could have accumulated at the front, this is a major contributor to compressor failure. check also the fan near the compressor. it should be running at the same time the compressor runs.
that's nice to hear from whirlpool....
good luck tapperal,
tnx 4 using fixya,
Posted on Oct 07, 2008
it's probably a fuel injection problem. the seals wear or get some little bit of junk in seal surface and are unable to completely close. it's not a problem as long as the engine is running, the seals let in a little more fuel and the computer adjusts for it. after you shut it off the leaky seals let the fuel into the cylinders and then if you try to start it up it is for all intents and purposes a flooded engine. if you don't try to start it again for a good while the fuel that leaked into the cylinders evaporates or runs down into your oil pan. anyway, it's not there and so your engine is not flooded and it starts like it's supposed to. obviously i haven't looked at your vehicle and that's just a guess but it's based on vehicles i have seen. hope that helps
Posted on Jun 03, 2009
Tips for a great answer:
Jul 21, 2014 | Sub-Zero 601R
Jun 23, 2014 | Sub-Zero 601R
Jan 16, 2014 | Sub-Zero 601R
Nov 26, 2010 | Sub-Zero 601R
Sep 26, 2009 | Sub-Zero 650 / O Bottom Freezer...
Jul 15, 2009 | Sub-Zero 601R
Jun 27, 2009 | Sub-Zero 601R
101 people viewed this question
Usually answered in minutes!