Hello, my mx300 isnt recieving any faxes but everything is hook up right, whats the problem?

clean the rollers in the paper path

Please rate my help++++Thanks for using FIXYA

Probably means to replace the c-crt (ink cartridge c).

maybe your refill the crtg and than must turn on the masej PRINT WHEN NO INK OUT

You need to run the software that came with that all in one printer to configure the fax features and after that everything should be working for you....

Check out the Easy Setup Instructions available here. If you can neither send nor receive faxes, you may not have the phone line connected to the correct port, see page 34 of the guide. Also check what receive mode the machine is set for. Pages 42 and 43 explain the different options and how to change the receive mode.

Dear friend,
it's very important to connect your MX 300 with the telephone line the right way! Please read once more the part "Preparing the machine for fax" in the chapter "Faxing" of the MX 300 User's Guide and mind the hint "Important: Do not connect the machine and external devices in parallel to the same telephone line using a splitter (A). The machine may not operate properly."

Greetings from Cologne (Germany) to the UK!

i cant send fa with my Canon MX300

I found this on Canon's website.

Remote RX If the fax interrupts telephone conversations after the initial sixty seconds that it uses to monitor for fax signals, change the Remote RX ID number. The default Remote RX ID number is 25. See the folloing steps to change the Remote RX ID number.

1. Press the <FAX> button to enter the Fax menu.
   
   
2. Press the <Menu> button.
   
   
3. Press the left or right arrow to select [RX SETTINGS], then press <OK>.
   
   
4. Press the left or right arrow to select [REMOTE RX], then press <OK>.
   
   
5. Press the left or right arrow to select [ON] or [OFF], then press <OK>.
   
   Note: The default setting is [ON].
   
   1. If [Remote RX] is set to [ON], a window will appear displaying the current REMOTE RX ID.
      
   2. Use the left or right arrow to select the preferred ID value (from 00 through 99).
      
   3. Press <OK> to set the ID.
      
      
6. Press the <Fax> button to return to Fax standby mode.
   

If the fax continues to interrupt telephone conversations after the Remote RX ID number was changed, turn off Remote RX. The default setting from the factory is ON. See the folloing steps to turn off Remote RX.
1. Press the <Menu> button until [FAX SETTINGS] is displayed.
2. Use the [ ] or [ ] to select [RX SETTINGS] then press <OK>.
3. Use the [ ] or [ ] to select [REMOTE RX] then press <OK>.
4. Use the [ ] or [ ] to select [OFF] then press <OK>.
5. Press <Stop/Reset>.

hi i am a certified Canon repair tech for this printer. if you follow the link below this will take you to Canons support site where you can download the software for your printer. hope this helps

http://www.usa.canon.com/consumer/controller?act=DownloadIndexAct

you need to watch during ringing period need to click ok or press what ever message says.