Your manual may have the instructions
http://www.manualsonline.com/
SOURCE: replacing the drive belt Nordictrack
basically you will be just about to take your treadmill, almost totally apart. But the are not many nuts and bolts to solving your problem, first Lay treadmill on its side and locate the rear roller bolts, on mine their are 2, most tread mills are all the same, remove them 2 bolts, Now locate the front roller bolt, 1 bolt,remove bolt, your belt is going to be very loose now, on the side that you would be walking on, Is a board, 6 phillips head screws, Hold the board to the metal frame, remove them, remove the board, then go back to the rear roller, And remove the plastic end caps that hold the rear roller too the metal frame, by gently tapping them off, remove old belt from rear roller, Now go to front roller, and remove belt from front roller, and its time to Install new Belt, AND AJUST NEW BELT, Put belt on front roller and reinstall roller, put plastic end caps back on frame, and then reinstall rear roller threw the belt and reconnect to the plastic end caps on the rear of the frame, Now reinstall the board with 6 phillip screws, to the metal frame, Now turn treadmill upright again, Its time to AJUST YOUR NEW BELT 1st Center your New Belt, Then tighten rear roller bolts, ( Pay Attention ) Count even amount of turns for both Rear roller bolts, Then Ajust front roller Alignment, Their is only 1 bolt on most treadmills, So if your belt is pulling to one side when you turn the treadmill on,it means you still have to ajust the front roller ajustment screw, What I Do Is , I USE A small leveling tool, For the front roller ajustment, It KEEPS the pitch EVEN on both sides of the front roller, and this is HOW YOU REPLACE YOUR BELT AND AJUST THE NEW BELT, and save your self some money, enjoy, in you need to contact me, [email protected]
SOURCE: How do you replace the drive belt on a Nordictrack
You get full installation instructions when you order through Treadmill Parts.
SOURCE: Need to replace the drive belt on my Weslo Momentum 610 elliptical
Which version of the Momentum 610 do you have? Here is a drive belt for the WLEL14051 and WLEL14052. There are a few slightly different model numbers for the Momentum 610 listed here that do not have drive belts listed in their parts list, so it is possible that the first link works for those two, but I could contact them to make sure.
SOURCE: My NordicTrack E5 vi Elliptical is squeaking really bad. How do I fix this problem?
go to :http://www.ehow.com/how_4681374_fix-elliptical-machine.html
God bless you
SOURCE: Nordictrack Asr 1000 Elliptical Resistance Motor
1) Adjust the cable tension
2) Adjust the magnet, for loose bolt, test the magnet with the refrigerator magnet, for repulsion and attraction, Replace if necessary buying in any Hardware store, for small price.
God bless you
256 views
Usually answered in minutes!
×