Why isn't display working? - Bosch Dishwashers

Try another cable

Hello, Are you sure you have not turned off the LCD display by mistake. Check your settings.
Best Regards, Russell

The display control will need to be replaced. It may be cheaper to replace the unit since the control is so expensive. Here is a link to the part you need.
Keep me posted!

What is the complete model number of your unit?

1) Try to dry the display with gun drier for 15 minutes with a distance about 12 inch.

2) Wait after you dry by 15 minutes, and try again.

3) If the problem persist the display board is faulty. you must replace.

go to www.repairclinic.com and buy it.

God bless you

check for power at the display if power is present then you need a new interface (display) if no power is there then you need a new mother board located on the back of the unit square panel..mother board part#- WR55X10942--interface (display)-part#WR55X10390

TI calculators have an annoying habit of dimming the screen, especially when the batteries are changed, so that it appears as if the calculator isn't turning on. Turn the calculator on (or at least press the ON key). Press and release the 2ND key. Press and hold the Up-arrow key for a few seconds and see whether the screen becomes legible.
If this isn't the problem, please reply to this post and give a fuller description of the problem.

Is it when you do playback on tape or when you do a recording

If all buttons don't work then check that connection isn't broke through the I/O board.
If not then board is faulty.
Is you display is lightining or not.
if not then the connction is bad

thanks
please rate my work

check the display cable that it isn't get damaged or loose.
thanks
please rate my work