Kenmore HE3T no water

Raise up your washer slightly or feel for 3 screws right under the front, bottom. Unscrew these and pull down - you will find the lint trap. Be prepared for water, and since the model is 2002 - immense junk too!
Pl say so if helped!!

my Kenmore He3T Stop But Remain have water on the bottom!!!
What happen

2 Beeps/E20--Error: Water dosen't drain. Cause: Drain is kinked or household clog. Correct.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

remove drawer and clean it. sometimes its just adjustment also

bad fill valve

Does this change if you select a cold wash or a hot wash? What's the water temperature feel like when it fills? I'd suspect the water control solenoid for either the hot or cold water isn't shutting off completely. This could possibly be due to a piece of debris or mineral deposit in its seat, and could be cleaned with CLR or citric acid if you remove it. They're not very expensive and not a very hard item to change on most machines.

most liklet to be a split pipe under the mashine lay it onits side and look under it at all the pipes replace the loos or split one

In my HE3T, this was indicative of the water pump going out. In its 8th year, my HE3T is now on its 3rd water pump.

Kenmore HE3t sanitary cycle setting has changed. Water temp selection only allows Hot/Cold selection but should offer the Extra Hot selection. All other settings test out properly. Is there a way to reset factory settings for cycles?

boot tear in front replace