I have no sound on my Kodak ektrasound projector modos 265

If your Kodak 600H projector is beeping when you turn on the lamp but stops when you turn off the lamp and leave the fan and power on, it could indicate an issue with the lamp or its connection. Here are a few possible explanations:
1. Lamp Replacement Needed: The beeping sound could be an indication that the lamp needs to be replaced. Projector lamps have a limited lifespan, and when they reach the end of their life, they may produce warning signals, such as beeping, to alert the user.
2. Lamp Connection Issue: Check the lamp's connection to ensure it is properly seated and securely connected. If the lamp is not properly connected, it may trigger an error and cause the beeping sound. Try removing the lamp and reattaching it, making sure it is correctly aligned and connected.
3. Lamp Compatibility: Ensure that you are using a compatible lamp for your Kodak 600H projector. Using an incompatible or non-genuine lamp may cause compatibility issues, triggering the beeping sound.
If none of the above steps resolve the issue, it is recommended to consult the user manual for troubleshooting instructions specific to your projector model. Additionally, contacting Kodak customer support or reaching out to a qualified technician for further assistance may be beneficial.

Your projector problem sounds like a broken cycle solenoid LINK. The LINK will be available from: www.micro-tools.com
They should have installation instructions, as well. See the attached picture for more details. Good Luck!! Jim

Your problem is most likely related to cycle contact adjustment. See the attached illustration for the parts involved and the SPECIFIC POSITION of the contact parts:

Check with www.micro-tools.com for parts and manuals!! They have an amazing inventory of classic Kodak parts for slide & movie projectors! Good Luck !! Jim

See my other response! Check with the George Eastman House in Rochester, NY for leads on the manuals! Good Luck !! Jim

It sounds like you need the timing adjusted in the projector. The pressure pads that hold the slide vertical in the projection gate are closing too soon. Check the Kodak website for the service procedure for this adjustment. If you need assistance, contact an authorized warranty repair dealer. Good Luck !!

What type of sound equipment are you trying to connect?? What exactly are you trying to achieve?
There was a Kodak accessory called the Kodak EC Sound Syncronizer. This product allowed you to blend a music track with a slide projector control track that, once attached to a recording device, allowed you to have a pre-programmed slide show with audio. Is this what you are searching for??

Kodak Slide Projector Lens 75-125mm f/3.5 (Japan)Sestar" /> $50.00 Amazon.com 5,548 reviews Used Kodak Slide Projector Lens 75-125mm f/3.5 (Japan)Sestar $200 Kodak Ektapro Select 200-300mm f/3.5 Flat Field Zoom Lens for 35mm ...

1. Add to Shopping List
2. $55.00 Used Kodak Slide Projector Lens FF 100-150mm f/3.5 Ektapro
3. Kodak Apollo Zoom Lens 100mm-150mm f3.5 Projector Lens
   
4. Used Kodak Slide Projector Lens 3" Kodak Ektanar Lens f/3.5

I have a Kodak Instamatic M70 Super 8 movie projector. How can I stop the film from continously jumping? I have adjusted every nob and looked inside to find nothing out of the ordinary.

This is a very common problem with these old Kodak projectors and is caused by a small part called the solenoid link that can be purchased separately or as part of this kit: https://www.micro-tools.com/store/item_detail.aspx?ItemCode=KODAK-KIT

There is also a guy on eBay, "atomk", who sells kits with very clear instructions on how to repair this problem yourself. Search for "Kodak Carousel Projector ADVANCE Repair Kit".

Good luck!