I have a Sanyo tv model #FW40D36F, Serial # ME2A1634260047 (A5G24UT). Heard a click sound and it shut off. TV is dead no power no light. Tried restart - nope. Is this likely the power board?

Question edited for clarity.
Question moved from Motorcycles category.

Shop Jimmy is the place for parts.

https://www.google.com/search?q=Sanyo+fw40d36f+parts

No Service Manual

https://www.google.com/search?q=sanyo+fw40d36f+service+manual

A cautionary tale

https://www.fixya.com/support/r29790007-repairing_own_television

..

No, because it isn't a smart television, just a nice one. Also it doesn't connect to the Internet.

https://www.sanyo-av.com/ca/product/product.php?id=570

Sounds like you heard a capacitor fail. Check the fuse on the power supply board and look for puffed up electrolytic capacitors on the power supply board and all the other boards in the TV. You can get replacement boards here: TV Parts Universal TV Stands DLP Chips ShopJimmy

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the sites linked here. Pull up older posts.
https://electronicshelponline.blogspot.com/ http://homenol.blogspot.com/
In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary. /

Now the tv it is completely dead no LED power light indication is on at all or the tv power LED light indication blinking too?Check the power source?Tries tv unplug,replug it back about an hour later for the tv do a resetting itself back to the factory setting,tv should be working again.If not the tv power supply board it is dead,that the board where the tv power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a whole new refurbish power supply board for the replacement.

This is a common problem with these TVs. You can download the official Sanyo repair manual for this TV (DP42746) at http://www.eserviceinfo.com/downloadsm/43343/sanyo_dp42746.html. I uploaded it here when I had the same issue with my TV last year. The solution is almost always to replace the Power Board (Y-Main) and the Upper and Lower Y Buffers. The parts and costs (from Sanyo in July 2009) are listed below (NOTE: Sanyo will not ship these parts to anyone but a repair shop): 1. V4 Y-Main (Y-Sustain) Circuit Board (Part # LJ92-01200A, Alt Part # LJ41-02759A) - USD $139.00
2. Upper Y-Buffer Circuit Board (Part # LJ92-01202A, Alt Part # LJ41-02760) - USD $64.00
3. Lower Y-Buffer Circuit Board (Part # LJ92-01203A, Alt Part # LJ41-02761A) - USD $64.00
Sanyo charges USD $10.50 for shipping, which brings the total cost for parts to USD $277.50. From my research, a shop would probably charge between USD $500 and $700 to do this repair. FYI - there is a class action lawsuit pending against Sanyo for this issue. The V4 Y-Main (Y-Sustain) Circuit Boards fail VERY frequently in this TV due to overheating. Hope this helps.

U restart the tv,u hear alots of clicking?That mean the Ballast is dead or have problems,that why ur picture lamp not sustaning the picture.Replacing the Ballast might or will sustance the picture.

Ur high voltage is dead,FBT,flyback trasformer it dead.The big block of plastic with a red wire hook a cap to the CRT(tv ttube).

Could be main or power board