Question about ASUS A7V8X Motherboard

2 Answers

Presario SR1030AN Turning on but not booting or POST or no any beep at all.

Presario SR1030AN.
I can turning on the PC but not booting or POST or no any beep at all.

What happen was that a couple of months ago I just replaced a hard disk and everything was fine. But a week ago, I tried to switch on the computer that I used till the previuos night, but nothing happen. I checked the rear and found the PS LED on the rear is only flashing. So I went through the procedures to diagnose the fault. the flashing LED came steady when I removed the 10-pin ATX power supply from the mobo with everything removed except the microprocessor (Athlon Xp 2500+). I ordered and replaced the mobo, but it came up with the same flashing the PSU LED. But I kept it for about 10 seconds, the led coming steady and the PC now can be turned on, but no booting nor nothing on the screen (monitor is good).

Please help me,

Thanks in advance.

Posted by on

  • engthava Nov 30, 2007

    Yes raevenzero,

    thanks for ur reply, Today I just replaced the PSU but no luck, samething, no change in its status, that is PC is turning on, but no booting nor nothing on the screen (monitor is good) , no beep. So till now I replaced the mobo and psu, no luck. is it something that with BIOS or some thing else ?

    Please help.



2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Regarding on your problem sir , when a computer has power but no beeping sound and no display it refers tha naybe the problem is in your motherboard or your already change your motherboard but still no display appeared on your monitor because the problem is in your processor ..tried to replaced your processor and it did owrk again ..(^_^) ..jhay from phillipines

Posted on Dec 02, 2007

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 questions.

  • Expert
  • 53 Answers

Have you tried switching the power supply out with one that is known good?

Posted on Nov 26, 2007

  • Ryan Wilson
    Ryan Wilson Nov 30, 2007

    You bios is part of your motherboard. Swap your processor and try using one one stick of RAM at a time. Process of elimination will kill this bug, however, I hope you have nice friends that you can borrow parts from.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Bepps when turning on

You need to be more specific. How many beeps? Did you add any new hardware? Were you doing anything inside the case? Does it boot up at all? Are there any messages on the screen?

Jun 25, 2012 | HP Compaq Presario SR2180NX (RK548AA#ABA)...

1 Answer

Beeps when is turning on

You need to be more specific... How many beeps? Did you add any new hardware? Were you doing anything inside the case? Does it boot up at all? Are there any messages on the screen?

Jun 25, 2012 | HP Compaq Presario SR2180NX (RK548AA#ABA)...

1 Answer

Computer wont boot, the fans keep running

Does it come with any beep sound, because beep sound clarify the fault. Check it by the way.
The list is given below.

No Beeps Short, No power, Bad CPU/MB, Loose Peripherals
One Beep Everything is normal and Computer POSTed fine
Two Beeps POST/CMOS Error
One Long Beep, One Short Beep Motherboard Problem
One Long Beep, Two Short Beeps Video Problem
One Long Beep, Three Short Beeps Video Problem
Three Long Beeps Keyboard Error
Repeated Long Beeps Memory Error
Continuous Hi-Lo Beeps CPU Overheating

best of luck!

Mar 07, 2012 | Compaq Presario S4040SE - (refurbished)...

1 Answer

Why does my compaq presario SR1810NX turn off immediately after turning it on ?

Beep sounds indicate a hardware problem, check you RAMs, remove them and air blow the RAM + its trays on the motherboard then try to boot up again.

Feb 20, 2012 | HP Compaq Presario SR1810NX PC Desktop

1 Answer

Compaq presario beeps 3 times, won't boot

3 Beeps is usually a RAM issue. Try re-seating your RAM in their slots and rebooting.

Feb 05, 2012 | HP Compaq Presario SR5262NX Desktop PC

1 Answer

Tower is On, fan inside is spinning, no beep, not reponding to monitor, monitor is in working condition

You will want to go through my published guide entitled My Computer is not turning on!!! Is it dead!!! No POST!!!

Your computer has failed the POST test. No beep confirms this. Try cleaning the RAM and reinstalling.

However it is probably due to a faulty mainboard.
Diagnose the problem first though.

Take care!

Apr 17, 2011 | Compaq Presario SR1703WM PC Desktop

1 Answer

Tried everthing just cant get this thing to boot up

Sounds like you may need your screen replaced.

Upon turning on your laptop,
Keep pressing F8, until you hear a beep. This will give you the option to boot to safe mode. When you hear a beep, and NOTHING comes on your screen within 20 seconds, you need to have your LCD screen replaced.

Typically if its a hardware problem such as RAM, you'll hear 2 beeps or a POST message will display on your screen, letting you know that a certain piece of hardware failed.

Ive seen problems occur when people change a setting such as :
Right click on your desktop --> Properties --> Settings --> Advanced Button

And changing your DPI. This can cause your screen to go out (Not display anything). If its up to high chances are your LCD screen can not handle it. If you boot to safe mode, then you can fix this. Again if you cant boot to safe mode, then you have a mad LCD.

Give this a try and let me know what happens.

Oh one more things.

One thing i have also seen, more than once, and till this day i can not explain it, but a USB device plugged in. Remove ANY USB device plugged to your computer. Printer, FLASH Drive, Mouse, etc. Then turn on your computer.

If you have a floppy drive, remove the floppy.
If you have a CD/DVD in your tray, turn the computer on to take it out.

May 21, 2009 | HP Compaq Presario 2200 Notebook

1 Answer

Compaq Presario V2000 boots up, but

Getting into Windows Safe Mode Users who may not be able to boot into normal mode or are not able to ... "F8 Key.

Linux and UNIX pg command help |/pattern/, Start up at the first line containing the regular expression pattern. filename, A path name of a text file to be displayed.

LS-120 SuperDisk drive help Next, connect the power and boot the computer and install the software ... as the computer beeps or pressing and holding CTRL as the computer is booting up.

Theses site should get ya back on line. Read and follow instructions.

Merry Christmas, Good Luck...Please dont for get to Vote/Thank You.

Merry Christmas

Dec 22, 2007 | HP Compaq Presario V2000 Notebook

2 Answers


are u getting any beep message ? let me know the model and the beep tone that you get, if you don't get any beep try changing ram if you have VGA card installed try changing that.

Dec 06, 2007 | Compaq Presario SR1000T (568657) PC...

Not finding what you are looking for?
ASUS A7V8X Motherboard Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top ASUS Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18424 Answers

Alun Cox

Level 3 Expert

2678 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Are you an ASUS Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides