Question about Panasonic PT-51HX41 51" Rear Projection Television

1 Answer

Color registration doesn't fit. The Blue is hanging to one side and it's a bit wider

Panasonic Proj. PT 51HX40B

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 934 Answers
Re: Color registration doesn't fit. The Blue is hanging...

Color registration doesn't fit?? Do you mean that you have a convergence problem and that the colors are not aligning?
That set uses two STK392-010 and all low ohm the feed resistors out front of the amp should be checked for change in ohm value: R7051, 7050, 7049, 7048 all of them are 10 ohms 1/2 watt.

Posted on Nov 26, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Panasonic PT-51hx40b projection TV powers off when I try to turn it on

Not sure if the transformer is bad or something on secondary side is pulling the voltage down--if replacing it cured the issue you did good.

If not try to disconnect at source on secondary side to see if with no load the voltage comes up.

Looking for either the xfmr to be bad or something shorted pulling the voltage it creates down.

May 14, 2012 | Panasonic Projection Televisions

1 Answer

Panasonic PT-51HX40B turns itself off and has no video, no lights

The buzzing noise that you were earing came from a bad ballast, and because of the bad ballast your lamp must have got out also, and that is were you are getting the burned smel from and also that is why you are no longer geteting any picture either.

So in this case you would have to replace the ballast board and the lamp on your tv set.

Jul 23, 2010 | Panasonic PT-51HX41 51" Rear Projection...

1 Answer

Tv wont turn on> is there a reset switch?

reset button can apply when the tv turns on. first the tv has a short circuit and has to be repaired in order to be able to reset the tv to the original settings created in the program as brightness, color etc.
your tv now needs a visit to the workshop first, to turn on.

Apr 14, 2009 | Panasonic PT-51HX40 51" Rear Projection...

1 Answer

Panasonic pt-51hx40b

big screen tvs are not made to come apart that way.the only thing you can do is take the back off it and i dont think thats going to help your situation

Dec 06, 2008 | Panasonic PT-51HX40 51" Rear Projection...

1 Answer

Panasonic PT-53WX52F Color blue adjustment

most likely the two convergence Ics need to be replaced. They are STK392-110 you can get replacements at the following link with free instalation instructions with pictures.

Jul 09, 2008 | Panasonic PT-53TW53 53" Rear Projection...

1 Answer

Panasonic PT-51HX40B

Check the board first, this it burned?

Jun 03, 2008 | Panasonic PT-51HX40 51" Rear Projection...

1 Answer

Panasonic PT-51HX40B convergence issue

Bit of a long shot but have you tried this??

Hope it helps!

Apr 28, 2008 | Projection Televisions

1 Answer

Panasonic T.V...

What is your tuner source? Cable,Satellite, antenna?...accordianman

Nov 13, 2007 | Panasonic PT-47WX49 47" Rear Projection...

2 Answers

Panasonic blue convergence problem

Yea, you have to have the two convergence Amp IC's replaced. Should run you about 300 bucks or so. Good Luck

Sep 14, 2007 | Panasonic PT-56HX41 56" Rear Projection...

Not finding what you are looking for?
Panasonic PT-51HX41 51" Rear Projection Television Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

Josh Whitehead
Josh Whitehead

Level 3 Expert

1142 Answers

The Knight
The Knight

Level 3 Expert

66456 Answers

Are you a Panasonic Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides