Need to reset lamp counters on a sharp XG-V10WU

hi
Do the following for resetting the lamp hour

1.Attach the power cord to the projector and plug it into an electrical outlet.
2.Locate the buttons on the top of the projector and simultaneously hold down the "Enter", "Menu" and "down arrow" buttons, then press the "Standby/On" button. 3.Continue holding all four buttons depressed until the lamp indicator light begins flashing green.The counter is now reset. Zero hours will now be displayed on the screen.
ok

To reset the timer go to the link below. It has the instructions.

http://unitedvisual.com/Pdf/SharpxgeCounter_Reset.pdf

Good Luck please rate 4 thumbs up and please leave a testimonial

the powersupply is failed

Have a nice day!
We supply original projector parts: lamp, bulb, Lcd panel, Lens, DMD chip, color wheel,
motherboard, powersupply ... with high quality and competitive price.
Jerry
Lampdeng Limited

Unplu the unit
Locate the user service screw, the lamp door should be underneath the projector.
open the lamp door
the lamp is removed by undoing 2 or 3 screws and pulling out with the handle.
a genuine replacement lamp with cage will mean you won't have to worry about wiring the lamp.
put new one in push connectors in firmly
do up the 2 or 3 lamp screws close the lamp door and screw up
reset procedure usually plug in power while holding down up, left and power and the lamp will be reset.

Hope this helps you
Good luck

Hope this helps

I would replace the Lamp. Too many times I have seen people reset the Lamp Timer and when the Lamp explodes, it also causes the Ballast to fail. At that point it may not be repairable due to parts not being available or the cost of them being through the roof.
Contact Sharps Customer Service and see if they could hook you up with a Lamp and the Lamp Timer Reset info.
That is my recommendation.
Skyassoc

I habe one of those
The probelem is you must use the exact same lamp model otherwise it wont run because of auto overload prevention
chek if you have the right sort of lamp,
fire the idiot what broke it,
find the manual- any codes/ instructions you need will be in it

hod down enter, menu, and down arrow, then press power.

check to see if the filter cover is open and/or the lens cover is open. there are switches in both openings, so see if the switches work (they are usually blue).

power supply or lamp ballasts, both are pretty common to produce results as you describe, looking at $600.00 or so to repair. if those are the only things wrong.

Your lamp is not lighting up most likely. Try removing the lamp assembly and clean the contacts. If that does not work then you will probably need to replace the lamp. Also try resetting the timers. Refer to you owner's manual for info on how.