sounds like a blowen bulb
doctor i think it's time to open her up and look inside from the back
open rear cover and turn it on look to see if all the bulbs are working
if a bulb is dead then you figured it out and with a little work can save some cash on a repair guy
PT-56wx33 56 in. No picture, just a green line down the middle. is
this a bad lamp, if so which...
(More)
PT-56wx33 56 in. No picture, just a green line down the middle. is
this a bad lamp, if so which one? Or do i have bigger problems.
I have a panasonic model#PT-56WX33,when I power on tv NO PICTURE,NO SOUND,nothing.Only the red power...
(More)
I have a panasonic model#PT-56WX33,when I power on tv NO PICTURE,NO SOUND,nothing.Only the red power light on tv panel lights up and blinks 5 times ovr-n-ovr.
I have the panasonic ap825 chassis, had the convergence problem, replaced the ics, then now it wont...
(More)
I have the panasonic ap825 chassis, had the convergence problem, replaced the ics, then now it wont boot, it blinks 3 times so i know its something in the convergence circuit, i found 2 bad resistors after the replacement, not smoked but varying resistance readings averageing 1/2 the spec, even being removed from the board and isolated ,but it booted fine before replacement of the convergence ics, is fixing the resistors likely to fix the issue, or did my new chips fry out too, i had no bridges or dry joints,im good at soldiering so im positive thats not the issue,...