Whirlpool Gold range door replacement

http://whirlpool.custhelp.com/app/chat/chat_launch will give you a chat line where the Whirlpool expert will chat with you and help you get your problem solved

Most of the beepers I am familiar with are built into the main control clock board assembly. The only way to repair this is to replace the whole main control board, not a cheap part.

Pull the knobs off and use a hair dryer blowing down the gas valve stems to dry out the spill. They should be fine once they are dry.

Try cheking the fuse first.

Take a wire coathanger and cut the long wire from the middle.
Bend a small "U" shape on one end.
Slide the "U" in from the left side of the oven door near the top center.
Moving the wire back and forth slowwly to grasp the lock latch.
When you feel the latch pull the wire firmly to the left to open the door.
Then have the latch mechanism repaired.

how about replacing the burners?

Gasket probably became dislodged, replace door gaskets, at 4 years old I would replace the gaskets, they are not expensive.

Hello welcome

Error code E2 means to
Check door/latch switch
and
Replace door switch if defective

Thank you Huum
Please leave a rating before you leave

hi thanks for the question. the sensor at fault is located in oven top left looks like a pen , replace the sensor thanks the appliance doc

If you have replaced the dual element with a new one, and have verified that you have the wiring installed correctly, it may be the infinite switch that controls the element that is bad. That would be the switch behind the control knob for the element in question.