Phillips plasma tv. Settings menu pops up all the

1) Is sound coming through the tv?
2) If you push menu button on remote does anything show on tv?

Go into the settings menu and see if you can cancel it from there.

Good day!!!!


I need some clarification...

If the settings is gone then go to the TV mode..or the settings is gone and no picture?..or the settings is gone then the back light is gone..

Please reply to this tread to give you a specific solution..

Thanks for using fixya...

Try to push the menu button on the tv itself numerous times and see if it will go away (since the buttons are not used often they become resistive and it could be any button,if that dont fix it then the main digital board is bad.

there is a soft ware upgrade for that problem on there web site you can down load it to a thumb drive and upgrade your set

there may be an issue with the push button on the side flaking out check and see if it is sticking on the cover if not I would replace that board

Yes. Its probably a stuck button on the TV's front panel. Try pushing or wiggling each button on the panel. It could be the channel up/down buttons or volume up/down, menu, etc.

When there is a button that is making slight contact, it keeps the microprocessor busy attending to the command its erroneously receiving from the offending button and may not allow other functions to work when this occurs.

It doesn't matter which button is stuck, any of the symptoms you describe can happen.

michtech

Your tv needs a software upgrade. This is usually done by a qulified service technician.

The Panasonic call center helped us with this one. Our Closed Captioning had been turned on through the TV settings. This made us have a black box with everything besides our cable. Turning off CC on our TV Main Menu solved the problem for us.

Five blinks is a severe hardware failure supplys not working. Viper is down. You have atleast a bad power supply board could have taken out your sustain boards. If you are good with a meter you can measure voltages and see if just your power supply is dead. If you have never handled a multimeter you will need a tech and a power supply is not cheap..Power supply is about a 600 dollar board.