My frigidaire fex831co will fill with water but not go into wash cycle but will rinse and spin when put in those cycles

SOURCE: Frigidaire Front Load Washer

You need to replace the Motor controller speed asm part number 134149220 they are about 165.00. very easy part to replace you have to remove the back panel and the control board is on the bottom left side two scews and two plugs.

SOURCE: My machine will fill & go thru a wash cycle but wont rinse or spin.

Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in the standpipe behind. Your hose should not fit airtight into the standpipe and neither too deep into it. Snaking out your standpipe would be good too.

Rate me pl.....if helped.

SOURCE: shutting down on rinse cycle

Hi this could means that you may need to replace the washing machine bearings. Once the bearings are bad, the motor overheats and it will automatically shut down after the first rinse.

Timonty from WashingMachineAdvisor.com

SOURCE: Whirlpool Model LSV6234AWO

door switch bad?

SOURCE: Basin will not fill with water during rinse cycle but will agitate and spin.

most new washers have cold water only rinse and spray rinse ck cold water coming into machine during wash if no cold comes in suspect cold side of fill vale not opening ..could be wiring issue or a bad valve