May Tag stackable washer model: MHWC7500YW doesn't do a fast spin at the end of the cycle and the timer doesn't function properly e.g. It say takes 17 min to finish but can take 30 mins.

Sure sounds like your timer has bit the dust. I'm not sure if the timer is still available. You have a great washer there. Good luck.

Kenmore stackable washer dryer doesn't cycle (doesn't advance to water fill or wash, drain, rinse, spin) (not spinning, draining, filling?) After the video, we learned it was the points in the timer. It wasn't the black "electrical plug", being plugged into. Get your serial number and google Kenmore timer and you can order a replacement timer. Even if you still have someone come out, you've still saved a bunch!.......ps....I had a viewer make a good point!; I obviously didn't have any issues, but obviously be careful with electrical panel and any loose wires!

you can take the top off and reach down and find the cord sticking out from the door lock, tug up on it and it will unlock.

Most likely the timer needs relaced.

The timer is not allowing a cycle stop for the neutral pack to drop. Replace the timer and you should be in good shape. The whistling sound is likely something in the pump.

Kelly

some of these machines have a timer conflict between rinse [ spin pulse ] and full spin at end of wash cycle the timer contacts remain in the pulse cycle the switching assembley may need replacing

The speed change voltages are selected by the timer contacts. Try rotating your timer clockwise rapidly through several revolutions then select a delicate spin cycle and see if the speed is still too fast. If it is then the most likely suspect is the timer itself.

http://www.appliancepartspros.com/part_details.aspx?part_id=2045983

Model number used: WSM2780WAWWW

The timers are the same.

Thanks for using FixYa.

Kelly

My May Tag washer don't spin and it washs continously

Have you checked and cleaned the filter on the machine, usually located and the front near the bottom. If so then there is 2 other possibilities, either your water pump at the back of the machine is blocked or faulty, or it's the timer on the machine. A washer won't go into spin mode until it has drained all the water from the machine first. hence the pump has to run. Just remember to drain all the water from the machine before checking your filter otherwise it will end up on your floor.